COMMANDER PLUS™ | CONTROLS AND FUNCTIONS |
|
|
a echo box, phaser, or reverb.
26.MASTER VOLUME CONTROL - This slider is used to control the master output level (main volume). To avoid distorted output try to maintain an average output signal level no greater than +4 dB. (see Channel Gain 32) To avoid speaker damage that may be caused by excessive volume, be sure this slider is always set to zero (completely down) before turning the unit on.
27.MASTER OUTPUT MONO/STEREO SWITCH - This switches the Master Output signal between stereo and mono.
28.MASTER OUTPUT BALANCE CONTROL - This knob is used to control the pan, adjust how much of the signal is sent to the left and right output level. For true stereo imaging, maintain the knob in the
12o’ clock position.
29.MASTER VOLUME LEVEL INDICATORS - The dual LED’s indicators are used to indicate the average master output level. The level indicators will directly reflect the MASTER VOLUME LEVEL (26).
30.CHANNEL EQUALIZER (“ROTARY KILLS” - BASS/MID/TREBLE CONTROL) - All of the chan- nels include a
CHANNEL TREBLE CONTROL - This knob is used to adjust the treble levels of a channel allowing for a maximum treble gain of 15dB or maximum decrease of
CHANNEL MIDRANGE CONTROL - This knob is used to adjust the midrange levels of a channel allowing for a maximum midrange gain of 15dB or maximum decrease of
CHANNEL BASS CONTROL - This knob is used to adjust the low frequency levels of a channel allowing for a maximum bass gain of 15dB or maximum signal decrease of
a channel signal.
31.SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to each channel. Each channel may only be assigned one input source at a time. This switch must be in the “phono” position for turntable operation.
32.CHANNEL GAIN CONTROL - This adjustment is used to adjust the audio source signal input gain for a channel. Never use the gain control to adjust a channels output volume. Setting the gain level properly will ensure a clean output signal. An improper gain level adjustment will send a distorted signal throughout the entire audio line which may damage speakers and amplifiers. To properly set a chan- nels the gain level control:
1.Be sure the MASTER VOLUME CONTROL (26) is set to level 8.
2.Set the CHANNEL FADER (10) to level 8.
3.Begin playback on an audio source connected to the channel you are adjusting.
4.Use the Gain Control to adjust an average output volume of +4 dB in the
©American Audio® - www.americandj.com - Commander Plus™ Instruction Manual Page 14