Channel LED Level Indicator | American Audio CommanderPlus guide

COMMANDER PLUS™	CONTROLS AND FUNCTIONS

CHANNEL LED LEVEL INDICATOR (33).

5.Repeat this step for all channels

33.CHANNEL VOLUME LEVEL INDICATORS - The LED’s indicators that run along each channels EQ section are used to measure incoming signal levels. Use these indicator to visually maintain an average signal output of +4dB. A consistent average output level of +4dB will produce a clean output signal.

34.LOW CUT BUTTON - This buttons is used to cut the bass frequencies out of the channel output signal. When this button is depressed the bass frequency level is cut by 100%.

35.EFFECT INSERT BUTTON - This buttons is used to insert an effect to the channel. Any external effect device connected to this unit will be inserted in to any channel that has the Effect Button engaged. When the effect insert is activated a red LED directly beside the Effect Button will glow.

36.MICROPHONE 1/MICROPHONE 2 COMBO JACK - Combination Microphone Jack. This jack will accept a standard 1/4 plug or XLR 3-pin balanced male plug. The volume output level for each micro- phone will be controlled by their respective CHANNEL SLIDERS (3).

COMMANDER PLUS™

CHANNEL LED LEVEL INDICATOR (33).