Peavey S-14P owner manual

Page 11

31.HEADPHONE OUTPUT: This stereo jack (TRS) provides drive for the headphones. The level is set by the headphone level control. Tip = Left, Ring = Right, Shield = Ground.

32.HEADPHONE LEVEL: This control sets the volume of the headphones.

33.HEADPHONE/METER SOURCE: Selects the signal(s) sent to the headphone amplifier and to the output meter array. Options include the main L/R outputs, monitor1, monitor2, or a cue mix of channel 11/12 and 13/14 pre-fader signals. This last position is useful for setting up tapes and CDs (on channels 11/12 and 13/14). Muting the stereo channels during cueing does not affect the headphone signal but prevents the audio from being sent to the speaker systems.

34.LED METER ARRAY: A 12 segment peak reading LED array monitors the level of the signals selected by the Headphone Source switch. When the switch is in the MAIN position, the meters monitor the left and right outputs. The 0dB reference level corresponds to +4dBu. In normal operation, the channel gains should be set so that the meters light near 0dB at loud points in the service. The output trim attenuator on the rear panel should then be adjusted for the desired house volume. This will give the best signal to noise ratio. The same procedure should be used on the monitor outputs, but the power amplifier input controls will need to be set for desired volume. Setting the output trim is part of the S-14 setup procedure.

31

32

33

34

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 14/S-14PMixing Console Operating Guide Page Important Safety Instructions Description EnglishChannel & Master Functions Page Page Page Master Functions 26 27 Page Input and Output Jacks Inputs & Outputs14P Model Features Only Setup Goal InstallationAutomatic Mixing Channels Planning the installationMonitor systems the good, the bad, and the ugly Stereo or mono Master operationOther outputs Setup ProcedureSetting the mixer to amplifier system gain Initial Adjustment of other Permanent microphones Setting Automatic mix inputsFeedback Ferret setup procedure Initial Adjustment of the Monitor 1 systemSetting the automix inputs 1-4. You are almost done Final setup and adjustmentSetting the Solo mics Wrapping it up Setting the stereo line inputsOperation Instructions To Set Advanced Control SetupAdjusting the Group Off Level Controls Setting the internal effects Adjusting the Group Compression ControlsAdjusting the Vocal Enhancer Ambience mic Setting the levelsPage Glossary S14 Block Diagram S14 Console · S14P Powered Console Hum & Noise Output Residual Noise Peavey Electronics Corporation Limited Warranty 2004
Top Page Image Contents