Peavey S-14P owner manual Hum & Noise Output Residual Noise

Hum & Noise

Output	Residual Noise	S/N Ratio (Ref. +4 dBu)	Test Conditions
Master L/R	-100 dBu	104 dB	All faders down
Mono	-85 dBu	89 dB	Master fader nominal, All channels muted
	-80 dBu	84 dBu	All controls nominal‚ mic gain min.
Left/Right	-100 dBu	104 dB	All faders down
	-85 dBu	89 dB	Master Fader Nominal‚ Ch. Faders Down‚ Ch. Muted
	-80 dBu	84 dBu	All controls nominal‚ mic gain min.

(Hum & Noise measurements: 22 Hz to 22 kHz BW)

Hum & Noise: -97 dB below rated output

Gain
Mic input gain adjustment range:	0 dB to 57 dB
Mic input to any output:	74 dB (max. gain)
Stereo Channel in to any output:	36 dB (max. gain)
Frequency Response
Mic input to L/R output:	20 Hz to 20 kHz (+0 dB / -1 dB)

Total Harmonic Distortion (THD)

<0.05%, 20 Hz to 20 kHz Mic to Left/Right Output (22 Hz to 22 kHz BW)

Equivalent Input Noise (EIN)

Damping Factor: > 100 @ 1 kHz‚ 4 Ohms

Input Impedance: 4.7 k Ohms

Dimensions ( H x W x D)
S-14:	19.0" (48.3 cm) Wide with Rack Ears
	16.7" (42.5 cm) Wide without Rack Ears
	14.3" (36.4 cm) Deep: on table top
	14.0" (35.5 cm) High: in rack
	5.9" (15.0 cm) High: on table top
	5.5" (14.0 cm) Deep: in rack

-129 dBu ( input terminated with 150 ohms‚ max gain)

Crosstalk

>80 dB adjacent input channels (20 Hz to 20 kHz)

>70 dB Left to Right outputs (20 Hz to 20 kHz)

Common Mode Rejection Ratio (mic input)

60 dB min. (20 Hz to 20 kHz)

70 dB typ. @ 1 kHz

Meters

S-14P:	19.0" (48.3 cm) Wide with Rack Ears
	16.7" (42.5 cm) Wide without Rack Ears
	16.2" (41.2 cm) Deep: on table top
	15.75" (40.0 cm) High: in rack
	7.2" (41.2 cm) High: on table top
	6.75" (40.0 cm) Deep: in rack
Weight
S-14:	17 lbs. (7.7 kg)
S-14P:	40 lbs. (18.2 kg)

12-segment peak reading (0 dB = +4 dBu)	Power Requirements
	S-14:	DOM: 120VAC 60 Hz 40 W Nominal
Signal/Overload Indicators		EXP: 230VAC 50/60 Hz 40 W Nominal
Red LED illuminates 2 dB below clipping

S-14P:

Power Section (S-14P Only)

Power and Load: 500 W RMS per channel into 4 Ohms; 360 W RMS per channel into 8 Ohms

Output Connections: Speakon output connectors are compatible with Neutrik NL2FC and NL4FC cable connectors. Connections are made to 1+ 1- only.

Frequency Response: 20 Hz–20 kHz (+0/-1 dB)

Total Harmonic Distortion: <0.1% at rated output @ 1 kHz

DDT™ Dynamic Range: Greater than 26 dB

DDT™ Maximum Distortion: Below 0.5% THD for 6 dB overload; Below 1% THC for 20 dB overload

DOM: 120VAC 60 Hz 525 W Nominal

EXP: 220–230VAC 50/60 Hz 525 W Nominal

EXP: 240VAC 50/60 Hz 525 W Nominal

30