Peavey S-14P owner manual 14P Model Features Only

Page 13

41.MONITOR OUT (XLR and 14"): 14" unbalanced and XLR balanced outputs of the monitor mix designed to feed an external monitor amplifier (Pin 2 is positive). The output level (nominal +4 dBu) is set by the individual channel, monitor-send controls and by the master monitor fader.

42.MAIN OUTPUTS (XLR and 14"): 14" unbalanced and XLR balanced outputs of the Left and Right mixes. The output level is set by the master Left and Right faders. The nominal levels are +4dBu.

43.AC MAINS INPUT: Connect the line cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used. Operate only with the specified AC input voltage applied.

S-14P Model Features Only

44.LEFT AND RIGHT POWER AMPLIFIER INPUTS: 14" unbalanced left and right inputs. Connecting to these inputs disconnects the mixer from the power amplifier.

45.POWER AMPLIFIER MODE SWITCH: This switch determines the function of the two internal power amplifiers. In LEFT/RIGHT mode, the amplifiers receive their signal from the main left and right outputs. Depending on the setting of the CONFIGURATION switch, the amplifiers will be stereo or dual mono zone outputs. In MAIN/MONITOR mode, the Left amplifier receives a mono sum of the left and right mixer outputs. The right amplifier receives the monitor 1 output.

46.AMPLIFIER INPUT LEVEL CONTROLS: These controls set the input level to the power amplifiers and are used to match nominal operating levels of the mixer to the power amplifier inputs.

47.AMPLIFIER OUTPUT CONNECTORS: Speakon output connectors. Connections made to 1+ 1-. These connectors are compatible with Neutrik NL2FC and NL4FC cable connectors.

42

40 39

38

41

45

44

46

47

13

Image 13
Contents 14/S-14PMixing Console Operating Guide Page Important Safety Instructions Description EnglishChannel & Master Functions Page Page Page Master Functions 26 27 Page Input and Output Jacks Inputs & Outputs14P Model Features Only Setup Goal InstallationAutomatic Mixing Channels Planning the installationMonitor systems the good, the bad, and the ugly Stereo or mono Master operationOther outputs Setup ProcedureSetting the mixer to amplifier system gain Initial Adjustment of other Permanent microphones Setting Automatic mix inputsFeedback Ferret setup procedure Initial Adjustment of the Monitor 1 systemSetting the Solo mics Final setup and adjustmentSetting the automix inputs 1-4. You are almost done Operation Instructions Setting the stereo line inputsWrapping it up Adjusting the Group Off Level Controls Advanced Control SetupTo Set Adjusting the Vocal Enhancer Adjusting the Group Compression ControlsSetting the internal effects Ambience mic Setting the levelsPage Glossary S14 Block Diagram S14 Console · S14P Powered Console Hum & Noise Output Residual Noise Peavey Electronics Corporation Limited Warranty 2004