Fostex VM04 Trim knobs, Scene Recall key, Scene Store key, Effect Parameter key, Effect Type key

Page 9

8. TRIM knobs

These volume knobs control the input gain of INPUT 1 and 2 according to the incoming signal level. Range: -10dBV~-50dBV. When you turn it clockwise, the gain will increase so that the Input socket can take low level signal inputs.

9. SCENE RECALL key

Use this to recall the Scene Memories. See SCENE MEMORY (page 22).

10. SCENE STORE key

Use this to store your own settings in the Scene memories. See SCENE MEMORY (page 22).

11. EFFECT PARAMETER key

Use this to set the Effect Parameters. See EFFECT MODE (page 18).

12. EFFECT TYPE key

Use this to set the Effect Type. See EFFECT MODE (page 18).

13. EXIT key

Use this key to quit the current mode.

See CHANNEL EDIT MODE (page 15), EFFECT MODE (page 18), SCENE MEMORY (page 22), FADER ADJUST MODE (page 23) and SETUP MODE (page 25).

14. ENTER key

Use this key to accept the current setting.

See EFFECT MODE (page 18), SCENE MEMORY (page 22), and SETUP MODE (page 25).

15. VIEW key

Use this key to choose which function to adjust and display on the LCD Display and VIEW Status Indicator.

16. DATA ENCODER

Use this dial to set the various values in each mode.

17. MASTER FADER

Use this to adjust the output level at the STEREO OUT jack.

18. INPUT FADERs

Use this to adjust the input level on the individual channel.

VM04 Owner’s manual

19. CHANNEL EDIT key

Press this key to enter the CHANNEL EDIT MODE. See CHANNEL EDIT MODE (page 15).

20. FADER ADJUST key

When you have recalled a Scene, if the Fader position is different from the Scene setting, this key will flash. Then, press this key to enter the FADER ADJUST MODE (page 24).

21. Contrast control knob

Use this to control the contrast on the LCD display.

22. LCD Display

This LCD shows various kinds of essential information. It consists of the Character part, Level display part, View display part, Channel Fader display part and Master Fader display part.

23. VIEW Status Indicator

Use this to confirm which mode you are setting when in the CHANNEL EDIT MODE. You can choose the mode by pressing the VIEW key. See CHANNEL EDIT MODE (page 15).

24. SCENE Number display

This shows the SCENE Number that has been recalled. See SCENE MEMORY (page 22).

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Introduction ModelSafety Instructions Table of Contents Effect Let’s examine the VM04 in more detailCH1 Input SectionMaster Section Buss SectionEffect Section EffectNames and Functions View Status Indicator Fader Adjust keyTrim knobs Scene Recall keyRemove the insulation paper Before UseApplication 2 To use as a Mono In/Stereo Out Effecter ApplicationsApplication 8 As a practise aid for your musical instruments Initial Setting Character section Normal Mix ModeChannel Edit Mode PAN settingRotate the Data Encoder EQ Hi setting EQ Lo SettingEffect Send setting Effect POST/PRE settingRotate the Data Encoder clockwise Delay Effect ModeReverb ChorusEffect Type setting Press the Exit key to quit the Effect ModeOne you want to choose Effect Parameter setting Pre-Delay Time setting Reverb Level settingReverb Time setting High Dump settingStore the setting that you have made Early Reflection Balance settingScene Memory Scene StorePress the Enter key after you have named your Scene Scene RecallPress the Scene Recall key Press the Enter keyFader Adjust mode Scene Direct RecallUseful info Setup Mode Fader Fix FdFixPress the Effect Type key and Effect Parameter key together Other modes Battery CheckSoftware Version Check Channel Fader Recall chRCLInput 1 Mixer SectionInput 3 Converter
Top Page Image Contents