Grizzly H8070 owner manual Installing Output Jack, Installing Bridge Pickups & Controls

4.Solder the pickup wires to the volume and three way switch as shown in the Wiring Diagram on Page 29 and the Electrical Photos on Pages 27-28.

5.Solder the audio jack wires onto the output jack.

Installing Output

Jack

Components and Hardware Needed:	Qty
Output Jack	1
Output Jack Cover	1
Chrome Screws 3.1 x 12mm	2
To install the output jack:

1.Thread the output jack onto the jack cover.

2.Place the output jack cover in the jack cavity, and mark the mounting holes.

3.Using a 1/16" drill bit, drill 3/8" holes at a 45º angle into the body as shown in Figure 24.

Figure 24. Drilling output jack mounting holes.

4.Mount the output jack cover with two 3.1 x 12mm screws.

-16-

Installing Bridge,

Pickups & Controls

To reduce humming in your amp, the ground wire must contact the bridge plate.

Components and Hardware Needed:	Qty
Guitar Body	1
Pick Guard	1
Chrome Screws 3.5 x 25mm	4
Chrome Screws 3.1 x 12mm	10
To install the control plate and pickups:

1.Tape the ground wire so the exposed por- tion curls over the bridge cavity as shown in Figure 25.

2.Place the bridge into the cavity so the plate makes contact with the wire.

Ground Wire

Figure 25. Ground wire above bridge cavity.

3.Secure the bridge with the 3.5 x 25mm screws, and fasten the control plate with 3.1 x 12mm screws.

H8070 Heirloom Telecaster-Style Guitar Kit