Operating Manual -
8. TROUBLESHOOTING TIPS
8.1 No Sound
Check the AC power. Is the power switch on and illuminated? Check the level meters. If they are operat- ing, the problem between the mixer and the later compo- nents in the system. If not, check to see you really have an input signal and that it is on the desired channel. Check that you have the master gain controls at the desired op- erating level.
8.2 Distorted Sound
Something is being overdriven in the signal path. If the clip indicators are active, reduce the channel level controls. If the clip indicators are still active, reduce the input signal level. If the level meters are constantly in the red, reduce the Master gain and increase the gain of components following the mixer. There are many gain adjustments in the mixer itself and probably several oth- ers in other system components which makes it possible to overdrive an input section and then incorrectly try to reduce the gain of the output section. The best way to approach setting gains is to establish the operating level
of input stages first by setting their gain as high as pos- sible but leaving about 20dB of headroom for loud peaks, then move on to set the master gain to produce a good meter reading. Proceed to set the gain of equalizers, lim- iters, crossovers, and amplifiers following the mixer in the same manner, always working toward the later stages of the system.
8.3 Excessive Noise
If the noise is in the form of hiss, the problem is usually due to an input stage set up for low gain and then compensating by increasing the master gain. Turn up the channel level controls and reduce the master gain.
8.4 Excessive hum
This is usually caused by "ground loops" in the system wiring. A complex sound system with many sources separated by significant distance and using sev- eral power outlets has many opportunities for this prob- lem to occur. If possible, feed everything in the system from one power source with a common ground.
If you need help, get in touch with your Ashly dealer or call an Ashly technical service representative at
9. DIMENSIONS
| 17.00 |
| 6.00 |
0.10 | |
1.15 |
|
1.75 | 1.25 |
Figure 9.1: Dimensional Drawing for LX-308B Mic/Line Mixer
8