| 2 | 1. Application tool | |
1 | installation bolt | ||
| |||
|
| 2. Hex wrench | |
|
| 3. Tighten | |
|
| 3 | |
012851 |
|
|
Put an application tool (optional accessory) on the tool flange so that the protrusions of the tool flange fit in the holes in the application tool and secure the application tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the application tool on the sanding pad so that it matches the sanding pad direction.
The sanding pad has a hook and loop type fitting system which allows easy and rapid fitting of a sanding paper. As sanding papers have holes for dust extraction, mount a sanding paper so that the holes in a sanding paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off. Loosen and remove the application tool installation bolt using a hex wrench and then take off the application tool.
| 1 | 1. Application tool | |
2 |
| installation bolt | |
|
| ||
| 2. | Holes in the | |
|
| ||
3 |
|
| application tool |
| 3. Adapter | ||
4 |
| 4. | Protrusions of |
|
|
| the tool flange |
012850
When using application tools with a different type of installation section, use a correct adapter (optional accessory).
OPERATION
WARNING:
•Before starting the tool and during operation, keep your hand and face away from the application tool.
CAUTION:
•Do not apply excessive load to the tool which may cause a motor lock and stop the tool.
012889 |
Put the application tool on the workpiece.
And then move the tool forward so that the application tool movement does not slow down.
NOTE:
•Forcing or excessive pressure on the tool may reduce efficiency.
•Before cutting operation, it is recommended to preset the orbital stroke rate 3 - 5.
Sanding
CAUTION:
•Do not reuse a sanding paper used for sanding metal to sand wood.
•Do not use a worn sanding paper or sanding paper without grit.
012853
Apply a sanding paper on the workpiece.
NOTE:
•Using a test material sample to try is recommendable to determine a correct orbital stroke rate suitable for your work.
•Use a sanding paper with the same grit until sanding the whole workpiece is completed. Replacing a sanding paper with different grit sanding paper may not get a fine finish.
Cutting, sawing and scraping
CAUTION:
•Do not move on the tool forcibly in the direction (eg. towards either side) of tool application with no cutting edge. It may damage the tool.
6