Intel SC5000 manual Remove Door, Removing the Hinge Pins

Page 14

Remove Door

1.Move the chassis so the door hangs over the edge of your workbench.

2.Open the door.

3.Press the plastic clip (Figure 5, A) in towards the chassis.

4.Pull the hinge pin (Figure 5, B) out with one hand while supporting the door with the other.

5.Slide the door to the left to remove it from the other hinge pin.

6.Remove the hinge pins and save for future use.

A B

OM09389

Figure 5. Removing the Hinge Pins

A.Plastic clip

B.Hinge pin

14

SC5000 Rack Kit Installation Guide

Image 14
Contents SC5000 Rack Kit Installation Guide Disclaimer Contents SC5000 Rack Kit Installation Guide Safety Guidelines Server PrecautionsEquipment Rack Precautions Safety Guidelines SC5000 Rack Kit Installation Guide Rack Installation Procedures Kit ContentsRemove Feet Removing the FeetRemove Top Cover Removing the CoverRemove 5 ¼-Inch Devices Removing a 5 ¼-inch DeviceRemoving Slide Rails Removing the Hinge Pins Remove DoorRemoving the Hinge Plate Remove Bezel Removing the BezelRemove EMI Covers Removing the EMI CoversRemove Right Side Cover Removing the Right Side CoverInstall Right Side Cover Installing the Right Side CoverInstall 5 ¼-Inch Devices into the Reorientation Bracket Installing 5 ¼-Inch DevicesInstall the 5 ¼-Inch Reorientation Bracket Installing the 5 ¼-Inch Reorientation BracketInstall Bezel Installing the Chassis Intrusion LockInstalling the Bezel Install Screw Plate Installing the Screw PlateInstall Front Cover Installing the Front CoverInstall Top Cover Installing the Top CoverInstall Rails Installing the HandlesRails Installed in a Rack SC5000 Šb ± ¿ ¼ Ã\ SC5000 ä ›‹XTé,!·K ˇX ESD ¼ã ˝ Kä SC5000 ä ›äc ⁄U¸‘˛ƒfi 5PbÍ ‚‘„è »Uı ¯˛éÒ,3W¿ ¯˛éÒ,3W¿ BƒÍ NØ˛éÒ,3W¿ ⁄ı5« ⁄ EMI ın¯˛éÒ±,3W¿ Âfi$ ›fl$ LflEMI ˛éÒ Œn ‘G’ ¸+‘⁄’\ü‹ ‚Õö ˚ö XØ˛éÒ ˚¤ªéÒ ⁄¯˛éÒ ⁄›-G» Œn-X ¶9JØ˛éÒ 21. Kcä