Intel SC5000 manual Install Front Cover, Installing the Front Cover

Page 25

Install Front Cover

1.For each 5 ¼-inch peripheral, remove the corresponding plastic cover.

2.If you have a hot swap bay installed, remove that plastic cover.

3.Position the bezel by sliding the tabs on the top under the bezel.

4.Tighten the thumbscrews.

OM09395

Figure 16. Installing the Front Cover

Rack Installation Procedures

25

Image 25
Contents SC5000 Rack Kit Installation Guide Disclaimer Contents SC5000 Rack Kit Installation Guide Server Precautions Safety GuidelinesEquipment Rack Precautions Safety Guidelines SC5000 Rack Kit Installation Guide Kit Contents Rack Installation ProceduresRemoving the Feet Remove FeetRemoving the Cover Remove Top CoverRemoving a 5 ¼-inch Device Remove 5 ¼-Inch DevicesRemoving Slide Rails Remove Door Removing the Hinge PinsRemoving the Hinge Plate Removing the Bezel Remove BezelRemoving the EMI Covers Remove EMI CoversRemoving the Right Side Cover Remove Right Side CoverInstalling the Right Side Cover Install Right Side CoverInstalling 5 ¼-Inch Devices Install 5 ¼-Inch Devices into the Reorientation BracketInstalling the 5 ¼-Inch Reorientation Bracket Install the 5 ¼-Inch Reorientation BracketInstalling the Chassis Intrusion Lock Install BezelInstalling the Bezel Installing the Screw Plate Install Screw PlateInstalling the Front Cover Install Front CoverInstalling the Top Cover Install Top CoverInstalling the Handles Install RailsRails Installed in a Rack SC5000 Šb ± ¿ ¼ Ã\ SC5000 ä ›‹XTé,!·K ˇX ESD ¼ã ˝ Kä SC5000 ä ›äc ⁄U¸‘˛ƒfi 5PbÍ ‚‘„è »Uı ¯˛éÒ,3W¿ ¯˛éÒ,3W¿ BƒÍ NØ˛éÒ,3W¿ ⁄ı5« ⁄ EMI ın¯˛éÒ±,3W¿ Âfi$ ›fl$ LflEMI ˛éÒ Œn ‘G’ ¸+‘⁄’\ü‹ ‚Õö ˚ö XØ˛éÒ ˚¤ªéÒ ⁄¯˛éÒ ⁄›-G» Œn-X ¶9JØ˛éÒ 21. Kcä