Intel SC5000 manual Install Top Cover, Installing the Top Cover

Page 26

Install Top Cover

1.Place the cover so the tabs go into the slots on the server. The cover should be flush against the chassis.

2.Slid the cover forward until it stops.

3.Tighten the two captive screws into the rear of the chassis.

OM09170

Figure 17. Installing the Top Cover

26	SC5000 Rack Kit Installation Guide

Image 26

Contents SC5000 Rack Kit Installation Guide Disclaimer Contents SC5000 Rack Kit Installation Guide Safety Guidelines Server PrecautionsEquipment Rack Precautions Safety Guidelines SC5000 Rack Kit Installation Guide Rack Installation Procedures Kit ContentsRemove Feet Removing the FeetRemove Top Cover Removing the CoverRemove 5 ¼-Inch Devices Removing a 5 ¼-inch DeviceRemoving Slide Rails Removing the Hinge Pins Remove DoorRemoving the Hinge Plate Remove Bezel Removing the BezelRemove EMI Covers Removing the EMI CoversRemove Right Side Cover Removing the Right Side CoverInstall Right Side Cover Installing the Right Side CoverInstall 5 ¼-Inch Devices into the Reorientation Bracket Installing 5 ¼-Inch DevicesInstall the 5 ¼-Inch Reorientation Bracket Installing the 5 ¼-Inch Reorientation BracketInstall Bezel Installing the Chassis Intrusion LockInstalling the Bezel Install Screw Plate Installing the Screw PlateInstall Front Cover Installing the Front CoverInstall Top Cover Installing the Top CoverInstall Rails Installing the HandlesRails Installed in a Rack SC5000 Šb ± ¿ ¼ Ã\ SC5000 ä ›‹XTé,!·K ˇX ESD ¼ã ˝ Kä SC5000 ä ›äc ⁄U¸‘˛ƒﬁ 5PbÍ ‚‘„è »Uı ¯˛éÒ,3W¿ ¯˛éÒ,3W¿ BƒÍ NØ˛éÒ,3W¿ ⁄ı5Â« ⁄ EMI ın¯˛éÒ±,3W¿ Âﬁ$ ›ﬂ$ LﬂEMI ˛éÒ Œn ‘G’ ¸+‘⁄’\ü‹ ‚Õö ˚ö XØ˛éÒ ˚¤ªéÒ ⁄¯˛éÒ ⁄›-G» Œn-X ¶9JØ˛éÒ 21. Kcä