Intel SC5000 Install 5 ¼-Inch Devices into the Reorientation Bracket, Installing 5 ¼-Inch Devices

Page 20

Install 5 ¼-Inch Devices into the Reorientation Bracket

1.Remove the two screws that hold the EMI shield in place.

2.Remove the EMI shield.

3.Slide the device into the bracket.

4.Insert and tighten the four screws removed when you removed the slide rails.

A

C

B

D

OM09392

Figure 11. Installing 5 ¼-Inch Devices

A.5 ¼-Inch device

B.Screws that hold the device

C.EMI shields

D.Screws that hold the EMI shields

20

SC5000 Rack Kit Installation Guide

Image 20
Contents SC5000 Rack Kit Installation Guide Disclaimer Contents SC5000 Rack Kit Installation Guide Safety Guidelines Server PrecautionsEquipment Rack Precautions Safety Guidelines SC5000 Rack Kit Installation Guide Rack Installation Procedures Kit ContentsRemove Feet Removing the FeetRemove Top Cover Removing the CoverRemove 5 ¼-Inch Devices Removing a 5 ¼-inch DeviceRemoving Slide Rails Removing the Hinge Pins Remove DoorRemoving the Hinge Plate Remove Bezel Removing the BezelRemove EMI Covers Removing the EMI CoversRemove Right Side Cover Removing the Right Side CoverInstall Right Side Cover Installing the Right Side CoverInstall 5 ¼-Inch Devices into the Reorientation Bracket Installing 5 ¼-Inch DevicesInstall the 5 ¼-Inch Reorientation Bracket Installing the 5 ¼-Inch Reorientation BracketInstall Bezel Installing the Chassis Intrusion LockInstalling the Bezel Install Screw Plate Installing the Screw PlateInstall Front Cover Installing the Front CoverInstall Top Cover Installing the Top CoverInstall Rails Installing the HandlesRails Installed in a Rack SC5000 Šb ± ¿ ¼ Ã\ SC5000 ä ›‹XTé,!·K ˇX ESD ¼ã ˝ Kä SC5000 ä ›äc ⁄U¸‘˛ƒfi 5PbÍ ‚‘„è »Uı ¯˛éÒ,3W¿ ¯˛éÒ,3W¿ BƒÍ NØ˛éÒ,3W¿ ⁄ı5« ⁄ EMI ın¯˛éÒ±,3W¿ Âfi$ ›fl$ LflEMI ˛éÒ Œn ‘G’ ¸+‘⁄’\ü‹ ‚Õö ˚ö XØ˛éÒ ˚¤ªéÒ ⁄¯˛éÒ ⁄›-G» Œn-X ¶9JØ˛éÒ 21. Kcä