Fujitsu MB15E07SL manual Absolute Maximum Ratings, Recommended Operating Conditions

Page 5

MB15E07SL

■ABSOLUTE MAXIMUM RATINGS

Parameter	Symbol	Condition		Rating		Unit	Remark

			Min		Max
			Min		Max

Power supply voltage	VCC	–	–0.5		4.0	V

	VP	–	VCC		6.0	V
	VP	–	VCC		6.0	V

Input voltage	VI	–	–0.5		VCC +0.5	V

Output voltage	VO	Except Do	GND		VCC	V

	VO	Do	GND		VP	V
	VO	Do	GND		VP	V

Storage temperature	Tstg	–	–55		+125	°C

WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current, temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.

■RECOMMENDED OPERATING CONDITIONS

	Parameter	Symbol		Value		Unit	Remark

			Min	Typ	Max
			Min	Typ	Max

	Power supply voltage	VCC	2.4	3.0	3.6	V

		VP	VCC	–	5.5	V
		VP	VCC	–	5.5	V

	Input voltage	VI	GND	–	VCC	V

	Operating temperature	Ta	–40	–	+85	°C

WARNING: The recommended operating conditions are required in order to ensure the normal operation of the semiconductor device. All of the device’s electrical characteristics are warranted when the device is operated within these ranges.

Always use semiconductor devices within their recommended operating condition ranges. Operation outside these ranges may adversely affect reliability and could result in device failure.

No warranty is made with respect to uses, operating conditions, or combinations not represented on the data sheet. Users considering application outside the listed conditions are advised to contact their FUJITSU representatives beforehand.

5

Image 5

Contents Description FeaturesPackages Pin plastic Ssop Pad plastic BCC FPT-16P-M05 LCC-16P-M06FPT-16P-M05LCC-16P-M06 PIN AssignmentsPin Ssop Pad BCC Name PIN DescriptionsPin no Descriptions SW FC LDS Block DiagramParameter Symbol Value Unit Remark Min Parameter Symbol Condition Rating Unit Remark MinAbsolute Maximum Ratings Recommended Operating ConditionsParameter Symbol Condition Value Unit Min Typ Electrical CharacteristicsVp/2 Vp − 0.5 V Vp Charge Pump Output Voltage Functional Description Shift Register Configuration Programmable Reference CounterPulse Swallow Function Serial Data InputProgrammable Counter Binary 7-bit Swallow Counter Data Setting Divide ratio a16383 2047LD/fOUT output signal ZC Pin Setting ZC pin Do output Normal output Power Saving Mode Intermittent Mode Control CircuitPS Pin Setting PS pin Status Do Output ControlOFF Parameter Min Typ Max Unit Serial Data Input TimingPhase Comparator Output Waveform Measurment Circuit for Measuring Input Sensitivity fin/OSCIN Fin input sensitivity Typical CharacteristicsOscin input sensitivity Do output current MA modeOscin input impedance Fin input impedancePLL Reference Leakage PLL Phase NoiseReference Information 500.0 ∝s/div Application Example Ordering Information Usage PrecautionsPart number Package Remarks 16-pin, Plastic Ssop FPT-16P-M05Pin plastic Ssop FPT-16P-M05 Package DimensionsFujitsu Limited F16013S-c-4-6 Dimensions in mm inches Index Area Pad plastic BCC LCC-16P-M06F0306 Fujitsu Limited