Multiquip manual MT-84F Rules for Safe Operation

Page 8

MT-84F — RULES FOR SAFE OPERATION

 

DANGER

Read this manual!

 

 

 

Failure to follow instructions in this manual may lead to serious injury or even death! This equipment is to be operated by trained and qualified personnel only! This equipment is for industrial use only.

The following safety guidelines should always be used when operating the MT-84F Tamping Rammer:

GENERAL SAFETY

■DO NOT operate or service this equipment before reading this entire manual.

■This equipment should not be operated by persons under 18 years of age.

■NEVER operate this equipment without proper protective clothing, shatterproof glasses, steel-toed boots and other protective devices required by the job.

■NEVER operate this equipment when not feeling well due to fatigue, illness or taking medicine.

■NEVER operate this equipment under the influence of drugs or alcohol.

■ALWAYS wear proper respiratory (mask), hearing and eye protection equipment when operating the rammer.

■Whenever necessary, replace nameplate, operation and safety decals when they become difficult read.

■Manufacturer does not assume responsibility for any accident due to equipment modifications.

■NEVER use accessories or attachments, which are not recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result.

■NEVER touch the hot exhaust manifold, muffler or cylinder. Allow these parts to cool before servicing

engine or rammer.

■High Temperatures – Allow the engine to cool before adding fuel or performing service and maintenance functions. Contact with hot! components can cause serious burns.

■The engine section of this rammer requires an adequate free flow of cooling air. NEVER operate the rammer in any enclosed or narrow area

where free flow of the air is

restricted. If the air flow is restricted it will cause serious damage to the rammer or engine and may cause injury to people. Remember the rammer's engine gives off DEADLY carbon monoxide gas.

■ALWAYS refuel in a well-ventilated area, away from sparks and open flames.

■ALWAYS use extreme caution when working with flammable liquids.When refueling, stop the engine and allow it to cool.

■NEVER operate the rammer in an explosive atmosphere or near combustible materials. An explosion or fire could result causing severe bodily harm or even death.

■DO NOT smoke around or near the machine. Fire or explosion could result from fuel vapors, or if fuel is spilled on a hot engine.

■Topping-off to filler port is dangerous, as it tends to spill fuel.

■Stop the engine when leaving the rammer unattended.

■Maintain this equipment in a safe operating condition at all times.

PAGE 8 — MT-84F — OPERATION & PARTS MANUAL — REV. #2 (06/30/05)

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Model MT-84F MT-84F Proposition 65 Warning MT-84F Operation & Parts Manual REV. #2 06/30/05 MT-84F Table of Contents MT-84F Parts Ordering Procedures When ordering parts Please supply the following informationMT-84F Safety Message Alert Symbols MT-84F Safety Message Alert Symbols Rotating Parts HazardsMT-84F Rules for Safe Operation MT-84F Rules for Safe Operation Machine Safety Decals Rammer Operation and Safety DecalsMT-84F Operation and Safety Decals MT-84F General Information Definition of Tamping RammerConstruction of Tamping Rammer Rammer Gearbox and Spring CylinderMT-84F Specifications MT-84F Controls and Components MT-84F Basic Engine Robin EH-12-2D Engine Controls and ComponentsFuel Check MT-84F OperationRammer Gearbox and Spring Cylinder Oil Bath Inspection Initial Start-upOperation Stopping The EngineLong Term Storage Maintenance200 300 Hours Pre-Cleaner MT-84F -TROUBLESHOOTING Guide MT-84F -TROUBLESHOOTING Guide NO. Column Part NO. ColumnQTY. Column Remarks ColumnMT-84F- Suggested Spare Parts MT-84F Rammer 1TO 3 UnitsMT-84F- Nameplate and Decals Part Name QTY Remarks MT-84F Crankcase and Engine Assy Part Name 28 MT-84F Operation & Parts Manual REV. #2 06/30/05 MT-84F Crankcase and Engine Assy MT-84F Guide Cylinder and Foot Assy Piston PIN MT-84F -TANK and Handle Assy Tank CAP ASSY., OR,DB Robin EH-12-2D Engine Crankcase and Cylinder Assy Robin EH-12-2D Engine Crankcase and Cylinder Assy Robin EH-12-2D Engine Crankshaft and Piston Assy Crankshaft CP Robin EH-12-2D ENGINE-MUFFLER, AIR CLEANER, CAM& CARB. Assy Robin EH-12-2D Engine -MUFFLER, AIR CLEANER, CAM& CARB. Assy Robin EH-12-2D Engine -GOVERNOR Assy Governor Lever CP Robin EH-12-2D Engine -RECOIL Starter and Blower Assy Robin EH-12-2D Engine -RECOIL Starter and Blower Assy Robin EH-12-2D Engine Magneto Assy Flywheel CP Robin EH-12-2D Engine Carburetor Assy Throttle Valve Effective October 1, 2002 Terms and Conditions of Sale Parts MT-84F Operation & Parts Manual REV. #2 06/30/05 Heres HOW to GET Help
Top Page Image Contents