Multiquip manual MT-84F Basic Engine, Robin EH-12-2D Engine Controls and Components

Page 15

MT-84F — BASIC ENGINE

Figure 3. Robin EH-12-2D Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers Engine manual for instructions & details of operation and servicing.

1.

Secondary Air Cleaner – Prevents dirt and other debris

 

from entering the fuel system. Remove wing-nut on top of

 

air filter cannister to gain access to filter element.

2.

Choke Lever – Used when starting the engine. Normally

 

used in cold weather conditions. In cold weather turn the

 

choke lever to the fully closed position, in warm weather

 

set choke lever half way or completely open.

3.

Spark Plug – Provides spark to the ignition system. Set

 

spark plug gap to 0.6 - 0.7 mm (0.024 - 0.028 inch). Clean

 

spark plug once a week.

4.

Muffler – Used to reduce noise and emissions.

5. Recoil Starter (pull rope) – Manual-starting method. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

6. Engine ON/OFF Switch – Controls the starting and stopping of the engine. Switch must be in the "ON" position when starting the engine.

Operating the engine without an air filter, with a damaged air filter,

NOTEor a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER

operate the engine with the muffler removed.

MT-84F — OPERATION & PARTS MANUAL — REV. #2 (06/30/05) — PAGE 15

Image 15
Contents Model MT-84F MT-84F Proposition 65 Warning MT-84F Operation & Parts Manual REV. #2 06/30/05 MT-84F Table of Contents When ordering parts Please supply the following information MT-84F Parts Ordering ProceduresMT-84F Safety Message Alert Symbols Rotating Parts Hazards MT-84F Safety Message Alert SymbolsMT-84F Rules for Safe Operation MT-84F Rules for Safe Operation Rammer Operation and Safety Decals Machine Safety DecalsMT-84F Operation and Safety Decals Rammer Gearbox and Spring Cylinder MT-84F General InformationDefinition of Tamping Rammer Construction of Tamping RammerMT-84F Specifications MT-84F Controls and Components Robin EH-12-2D Engine Controls and Components MT-84F Basic EngineMT-84F Operation Rammer Gearbox and Spring Cylinder Oil BathFuel Check Initial Start-up InspectionStopping The Engine OperationMaintenance 200 300 Hours Pre-CleanerLong Term Storage MT-84F -TROUBLESHOOTING Guide MT-84F -TROUBLESHOOTING Guide Remarks Column NO. ColumnPart NO. Column QTY. ColumnMT-84F Rammer 1TO 3 Units MT-84F- Suggested Spare PartsMT-84F- Nameplate and Decals Part Name QTY Remarks MT-84F Crankcase and Engine Assy Part Name 28 MT-84F Operation & Parts Manual REV. #2 06/30/05 MT-84F Crankcase and Engine Assy MT-84F Guide Cylinder and Foot Assy Piston PIN MT-84F -TANK and Handle Assy Tank CAP ASSY., OR,DB Robin EH-12-2D Engine Crankcase and Cylinder Assy Robin EH-12-2D Engine Crankcase and Cylinder Assy Robin EH-12-2D Engine Crankshaft and Piston Assy Crankshaft CP Robin EH-12-2D ENGINE-MUFFLER, AIR CLEANER, CAM& CARB. Assy Robin EH-12-2D Engine -MUFFLER, AIR CLEANER, CAM& CARB. Assy Robin EH-12-2D Engine -GOVERNOR Assy Governor Lever CP Robin EH-12-2D Engine -RECOIL Starter and Blower Assy Robin EH-12-2D Engine -RECOIL Starter and Blower Assy Robin EH-12-2D Engine Magneto Assy Flywheel CP Robin EH-12-2D Engine Carburetor Assy Throttle Valve Effective October 1, 2002 Terms and Conditions of Sale Parts MT-84F Operation & Parts Manual REV. #2 06/30/05 Heres HOW to GET Help