AR13D RIDE-ON ROLLER — ROLLER COMPONENTS
Figure 5. Roller Components 2
Figure 5 shows the location of additional components for the AR13D compaction roller. The function of each component or control is described below:
26.Front Sprinkler System – A gravity feed spray bar is provided for the wetting the roll for asphalt pavement.
27.Hydraulic Manifold – Aluminum block that controls the flow of hydraulic pressure to the various hydraulic motors and other components required to control the roller.
28.Hydraulic Oil Filter – Filters return oil from the front and rear hydrostatic motors.
29.Fuel Filter/Fuel Pump – Electrical device that pumps fuel from the fuel tank to the carburetor.
30.Hydraulic Pump – This unit incorporates an axial variable displacement hydraulic piston pump.
31.Front
32.Hydraulic Motor – This hydraulic motor controls the rotation of the vibratory system.
33.Bunjee Latch – Pull this rubber latch upward and back to gain access to the engine/pump compartment.There is one rubber latch located on each side of the unit.
34.Steering Cylinder – Controls direction of roller.
35.Engine – This roller incorporates a Briggs & Stratton DM850D,
36.Hydraulic Fluid Filler Port – Remove this cap to add hydraulic fluid. Fill with type ISO 46
37.Compartment Hood – Houses the engine, hydraulic manifold, accessory relay, hydraulic oil filter, hoses, and hydraulic pump. To lift the compartment hood, release the rubber bunjee latches located on each side of the hood.
38.Compartment Hood Lift Point – Place hand here then lift upwards to lift compartment hood.
39.Hydraulic Motor – This hydraulic motor drives the roller during operation.
40.Rear Drum Zerk Grease Fitting – Grease this fitting
42.Hand Rail – Grab hold of this hand rail when lifting yourself onto the operator's platform.
PAGE 20 — AR13D