Multiquip manual AR13D RIDE-ON Roller Engine Components, Motor oil, +12 VDC electrical system

AR13D RIDE-ON ROLLER — ENGINE COMPONENTS

Figure 6. B&S 850D Diesel Engine Controls and Components

INITIAL SERVICING

The engine (Figure 6) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer's engine manual for instructions & details of operation and servicing.

1.Thermostat – Regulates the temperature of the engine coolant.

2. Oil Filler Cap – Remove to add engine oil.

3.Starter – Starts engine when ignition key is rotated to the "ON" position

4.	Oil Pan– Holds a maximum of 3.5 quarts (3.3 liters) of
	motor oil.
5.	Alternator– Provides charge for battery and voltage for
	the +12 VDC electrical system.
6.	Injection Nozzle – Injects diesel fuel into the cylinder.
7.	Glow Plugs – Heating element used for starting the engine
	in cold weather conditions.

8.Oil Drain Plugs – Remove to drain crankcase oil. Fill with recommended type oil as listed in Table 4.

9. Oil Filter – Spin-on type, filters oil contaminants.

10.Oil Dip Stick – Remove to check amount and condition of oil in crankcase. Refill or replace with recommended type oil as listed in Table 4.

12. Injector Pump– Provides fuel under pressure to the injector nozzles.

14. Air Filter – Prevents dirt and other debris from entering the fuel system. Unsnap air filter cover to gain access to filter element.

WARNING - BURN HAZARD

Enginecomponentscangenerateextremeheat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11) — PAGE 21