Multiquip manual AR13D RIDE-ON Roller Initial START-UP, Initial Start-up Instructions Starting

AR13D RIDE-ON ROLLER — INITIAL START-UP

Initial Start-up Instructions

Starting

CAUTION - General Operation Safety

DO NOT attempt to operate the roller until the Safety, General Information and Inspection sections have been read and understood.

1.Placeyourfootintotheroller'sfootstep,grabholdofthehand rail located on the steering console, and lift yourself onto the platform.

2.Sit down in the operators seat and adjust the seat for a confortable position, then fasten the seat belt (Figure 17) aroundyourwaist.NEVER!operatetherollerwithouttheseat beltbeingfastened,seriousinjurycouldoccuriftheseatbelt is not used.

Figure 17. Securing Seat Belt

3.Beforestartingengine,makesuretheimmediateareaisfree of obstructions and debris that may lay in the roller's path.

4.Make sure that the roller's shift lever (Figure 18) is placed in the neutral position.

PUSH-IN, THEN PULL

TO SET THROTTLE

(RPM’s)

THROTTLE RELEASE	PUSH ALL THE WAYDOWN
AND IDLE BUTTON	TO IDLE ENGINE

THROTTLE LOCK

KNOB, TURN CLOCKWISE

TO LOCK THROTTLE CABLE.

Figure 19. Throttle Control

6.Insert ignition key into ignition switch (Figure 20), turn key clockwise until glow plug indicator light turns ON, keep key in this position until glow plug indicator light turns OFF. Continue turning ignition all the way clockwise until engine starts, release key.

Figure 20. Ignition Switch

Figure 18. Shift Lever

5.PUSH the"RED" button(Figure19)onthethrottlecontroland

pull the round black knob about halfway out. Make sure that the throttle lock knob has been dis-engaged.

7.Iftheenginedoesnotstart,repeatsteps1through7 orconsult the troubleshooting guide contained in this manual.

8.Let the engine warm for 3 to 5 minutes before using roller. Check for fuel and oil leaks, and noises that would asso- ciate with a loose guard and/or covers.

9.If necessary return the choke knob to the full OPEN position.

AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11) — PAGE 25