ODGR Series Outdoor Gas Fireplace
|
| *Do not install |
|
| header until unit |
|
| is in place. |
|
| Standoff |
|
| Surround |
Nailing |
| Gas |
| Line Ac- | |
Flange |
| cess |
|
| Screen |
|
| Grate |
|
| Firebox |
FP1416 | Valve Access Panel | |
| ||
Fig. 8 | Parts identification. |
|
|
| Interior sides of an exterior chase |
|
| should be weather proof |
|
| *Do not install |
|
| header until unit |
|
| is in place. |
Standoff
Surround
Gas
Line
Access
Screen
Grate
Firebox
Valve Access Panel
Nailing Flange | FP1644 |
Fig. 9 Exterior chase installation.
Gas Line Installation
This appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure equal to or less than 1/2 psig (3.45 kPa).
The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.45 kPa).
If gas piping from the source to the appliance location has not been accomplished, install the required pipe. Consult local plumbing code to assure proper pipe size.
The gas pipeline can be brought in through the right side of the appliance. A knockout is provided to allow for the gas pipe installation and testing of any gas con- nection.
NOTE: The gas line connection can be made with 3/8" copper tubing approved for propane or natural gas, 1/2" rigid pipe or an approved flex connector, then reduced to 3/8" to the appliance. Because some municipalities have some additional local codes, it is always best to consult your local authority.
U.S.: Consult the current National Fuel Gas Code, ANSI Z223.1/NFPA 54.
Canada: CSA - B149.1 installation code.
Test for leaks. Use a 50/50 solution of liquid soap and water to test for leaks at gas fittings and joints. Apply water/soap solution with brush only - do not over apply. NEVER test with an open flame.
The gas control is equipped with a captured screw type pressure test point, therefore it is not necessary to pro- vide a 1/8" test point up stream of the control.
When using copper or flex connector use only approved fittings. Always provide a union so that gas line can be easily disconnected for burner or fan servicing.
See gas specification for pressure details and ratings. NOTE: If flex connector is used, it must be kept inside of the appliance. (Fig. 10)
1/2" Gas Supply | |
| 1/2" x 3/8" |
| 3/8" Nipple |
| 3/8" Union |
| 3/8" Nipple |
FP598 |
|
Fig. 10 | Typical gas supply installation. |
92D0001