14
INSTALLATION
Log Placement for M42E/VM42E Models
INSTALLATION
Continued
LOG PLACEMENT FOR M42E/VM42E MODELS
1.Place log 1A on the front left side of grate. Place log 1B on the front right side of the grate. See Figure 27.
2.Place large back log (log 2) onto grate making sure notches rest over grate. Insert peg on back of log 1A into hole on front left of log 2 (see Figure 27).
3.Place log 3 across log 1A and log 2, aligning peg on log 3 with top left hole on log 2 (see Figure 28).
4.Align peg on log 4 with inside left hole on log 2 (see Figure 28). Log 4 will rest on grate fingers as shown in Figure 29.
5.Align peg on log 5 with the inside right hole on log 2 (see Figure 29). Rest the lower part of log 5 on the log 4 and on grate as shown in Figure 30.
6.Align peg at the top of log 6 with outside right hole on log 2. Fit the peg at the lower part of log 6 into the hole on top of log 1B (see Figures 29 and 30).
To enhance the look of the hearth you may optionally place the lava rock provided around the front and sides of the burner pan.
NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the propane/LP
Log 1A
Log 2
Log 1B
Figure 27 - Installing Logs 1A, 1B and 2
Log 3
Log 4
Log 1A
Log 2
Log 1B
Figure 28 - Installing Logs 3 and 4
Log 5
Log 4 | Log 6 |
|
Log 2
Log 1B
Figure 29 - Installing Logs 5 and 6
Figure 30 - Logs Installed for M42E/VM42E Models
For more
visit www.
.com
