Chicago Electric 68887 manual Wire Spool Installation, Setup Basic Welding, Spindle

Wire Spool Installation

SAFETY

1.Turn the Welder to OFF and unplug it before proceeding.

MP FLUX WIRE WELDER

	ITEM 68887
		ON	MIN
		OFF	MAX
D SPEED	Wire	.030″-.035″ Flux-core
	Capacity XX Ga. – X/X″ Steel Plate
	Cables	Electrode – X′
		Ground Clamp – X′

120V~

SETUP

BASIC WELDING

2.Press in the pin at the top center of the control panel and open the cover.

3.Remove the Knob, Spring and the Top Plate.

If replacing a Spool, remove the old Spool and all remaining wire from the liners.

4.Place the new flux core Wire Spool over the Spool Spindle.

To prevent wire feed problems, set the Spool so that it will unwind counterclockwise .

Cover

Wire

Spool

Knob

Spring

Top Plate

Wire Spool

WELDING TIPS

MAINTENANCE

Spindle

5.Replace the Top Plate (turned as shown in illustration), the Spring and the Knob.

wire must

unwind this

direction

Page 8 For technical questions, please call 1-800-444-3353. SKU 68887