16.To check the wire’s drive tension, feed the wire against a piece of wood from 2 to 3 inches away. If the wire stops instead of bending, turn the welder to OFF, unplug it, slightly tighten the Feed Tensioner clockwise 
, and try again.
If the wire bends from the feed tension, then the tension is set properly.
030″.
Incrementally
increase tension
until
wire bends.
SAFETY
2
- 3″
17.TURN THE WELDER TO OFF.
18.Select a Contact Tip that is compatible with the welding wire used. The included Tip (.035″) will work with both .030″ and .035″ wire. Slide the Contact
Tip over the wire and thread it clockwise 
into the Gun. Tighten the Contact Tip using a wrench.
19.Replace the Nozzle and cut the wire off at 1/2″ from tip (1/2″ stickout).
20.Swing the Cover closed until the Cover Latch locks in place.
MP FLUX WIRE WELDER
| ITEM 68887 |
|
|
|
| ON | MIN |
|
| OFF | MAX |
D SPEED | Wire | ||
| Capacity XX Ga. – X/X″ Steel Plate | ||
| Cables | Electrode – X′ |
|
| Ground Clamp – X′ |
| |
|
|
| |
120V~
Gun
Nozzle
Contact
Tip
SETUP
BASIC WELDING
WELDING TIPS
MAINTENANCE
SKU 68887 | For technical questions, please call | Page 11 |
