INSTALLATION
Combustion Air Kit Model AK4 (Optional)
Appliance Enclosure
Installing Optional Glass Door Accessory
15
INSTALLATION
Continued
COMBUSTION AIR KIT MODEL AK4 (OPTIONAL)
The outside air kit may be installed on the left side of the fireplace only. The vent can be installed through the outside wall or a ventilated crawl space. The handle to operate the damper door for the outside air inlet will be located inside the left “screen pocket” of the firebox (see Figure 31). Pull the handle to open or push to close.
CAUTION: Air inlet ducts are not to terminate in attic space.
Screen Pocket
Air Kit
Handle
Figure 31 - Air Kit Handle Location
APPLIANCE ENCLOSURE
Before finishing the enclosure around the appliance, inspect all joints around the outer surround. Any gaps between the nailing flanges and the framing should be sealed with noncombustible insulation or caulking.
If the appliance is mounted on a raised platform, it must be a continuous surface and not on blocks without a solid surface. This will prevent the entry of cold air by means of conduction through the total bottom of the appliance. (see Figure 32).
INSTALLING OPTIONAL GLASS DOOR ACCESSORY
CAUTION: Use only glass doors certified for use with this appliance.
Note: Glass door may be heavy for some individuals. If this is the case, please request help from someone else.
The M36E, VM36E, M42E and VM42E
Follow these steps to install left and right panels:
1.With the handle at the bottom, completely fold the panel on its hinges.
2.With the handle facing the center of the firebox opening, in- sert the lower pivot pin on the glass door panel into the hole in pivot plate on the bottom edge of the fireplace opening (see Figure 33).
3.Keeping the folded door tilted, slide the upper two pins into the guide track found under the upper facial edge of the fire- box opening.
4.Tilt the glass assembly fully vertical until the outer pivot pin snaps into the mounting hole in the upper spring clip (see Figure 33).
Slide Top PinSpring Clip
Into Door Track
Insert Pin Into
Spring Clip
Side | Side |
|
Framing | Framing | Insert Bottom |
|
| |
|
| Pivot Pin Into |
|
| Pivot Plate and |
|
| Swing Door Into |
|
| Vertical Position |
Caulk Here | Pack Insulation | Pivot Plate |
Figure 32 - Sealing Between Appliance and Framing
Figure 33 - Installing Optional Glass Door
For more information, visit www.desatech.com