Desa EVDDVF36STN Operating Fireplace, For Your Safety Read Before Lighting, Lighting Instructions

Page 21

OWNER’S MANUAL

OPERATING

FIREPLACE

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the main burner. These mod- els do not have a pilot assembly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information in column one.

2.Open lower louver panel.

3.Turn wall switch to “OFF”.

4.Turn off all electric power to the fireplace.

5.Turn the equipment shuttof valve

clockwise to the OFF position (see Figure 52). Do not force.

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation in column one. If you don't smell gas, go to the next step.

7.Turn equipment shutoff valve counter-

clockwise to the ON position.

8.Turn on all electrical power to the appliance.

9.Turn the wall switch to the ON position.

10.Visually locate the electrode assem- bly. The electrode is located by the main burner. The ignitor should be- gin to spark and the main burner should ignite.

•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the main burner.

•If the appliance will not stay lit af- ter several attempts, follow the in- structions To Turn Off Gas To Ap- pliance, column 3, and call your service technician or gas supplier.

11.Close lower louver panel.

Equipment Shutoff Valve

Control Valve

Figure 52 - Turning the Equipment Shutoff Valve to the OFF position

TO TURN OFF GAS

TO APPLIANCE

1.Turn off the wall switch.

2.Turn off all electric power to the ap- pliance if service is to be performed.

3.Open control access panel.

4.Turn equipment shutoff valve clock- wise Clockwise to “OFF”. Do not force.

5.Close control access panel.

OPTIONAL REMOTE

OPERATION

Note: The WRC receiver and hand-held remote control kit must be purchased separately (see Accessories, page 26). Fol- low installation instructions on page 17.

1.Turn equipment shutoff valve to ON position. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 sec- onds to assure proper operation.

2.Press the ON/OFF button to turn the burner on and off.

Figure 53 - Electrode

106573

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents What to do if YOU Smell GAS Check Local Codes Prior to InstallationHorizontal termination above ground level clearances Glossary TermsIntroduction Selecting LocationBefore YOU Begin Clearances PRE-INSTALLATION PreparationMantel Clearances FramingLocation of Vent Termination General VentingGeneral Venting Installation Precautions Venting InstallationInstallation Planning Installing Vent System in a ChaseSnorkel Termination Installation for Horizontal TerminationVent Pipe Connections Rise per 12 of horizontal run Horizontal Termination ConfigurationsVenting with Two 90 Elbows Flat Ceiling Installation Installation for Vertical TerminationCathedral Ceiling Installation Connect a section of pipe and extend up through the holeVertical Horizontal H 1 + Min Max 20 max Vertical Termination ConfigurationsVertical Venting Parts Lists for Venting Kits and Components High Altitude InstallationVanguard Rigid Venting Vanguard Flexible VentingOptional Blower Assembly Installation Installing Optional Wall Mount Switch GWMS2Blower Speed Control Installation Blower Speed Control OperationGAS Line HOOK-UP Optional Remote Control Installation Model WRCGAS Supply Testing Installing LOG SETElectrode Assembly Adjustment Burner Flame AdjustmentElectrode assembly is factory preset for Decorative FacingBurner Removal Operating Guidelines and Maintenance InstructionsOperating Fireplace For Your Safety Read Before LightingLighting Instructions To Turn OFF GAS To ApplianceTechnical Service Service HintsReplacement Parts Wiring DiagramTroubleshooting Company Delayed ignition burner Manifold pressure is too lowBurner is lit Pane/LP gas companyLocate and correct all leaks Fireplace produces unwanted odorsFrom entering the unit. The maximum Is 1/4 for any horizontal runAccessories Replacement Parts High Voltage Cable GAS Control ValveRefractory Pieces Warranty Information

EVDDVF36PN, EVDDVF36STN specifications

Desa EVDDVF36STN and EVDDVF36PN are innovative and versatile electric heating solutions designed for modern indoor environments. These models stand out in the realm of electric heaters due to their advanced technologies, user-friendly features, and energy-efficient characteristics.

One of the main features of Desa EVDDVF36STN and EVDDVF36PN is their dual fuel capability, allowing users to harness the benefits of both electric and gas heating systems. This versatility ensures that users can maintain optimal comfort levels while minimizing energy costs. The models are equipped with a powerful heating element that can efficiently manage large spaces, making them ideal for homes, workshops, or commercial applications.

In terms of technology, both the EVDDVF36STN and EVDDVF36PN are engineered with a high-efficiency heating system that utilizes radiant heat to warm rooms quickly. This technology reduces the time required to reach desired temperatures, ensuring prompt comfort for users. Additionally, the heaters incorporate digital control systems that allow for precise temperature adjustments, enabling users to tailor their heating experience to meet specific preferences.

Another significant characteristic of these models is their sleek and modern design, which blends seamlessly into various interior styles. The cabinets are constructed from durable materials, ensuring longevity and resilience against wear and tear. Both models come with a variety of finishes and colors, allowing users to choose an aesthetic that complements their space.

The Desa EVDDVF36STN and EVDDVF36PN are also equipped with safety features that prioritize user well-being. These include automatic shut-off sensors that activate in case of overheating or if the unit tips over, providing peace of mind to users.

Moreover, these electric heaters are designed with energy efficiency in mind. They have a lower carbon footprint compared to traditional heating systems, contributing positively to environmental conservation efforts. Their efficient operation not only reduces energy consumption but also translates to lower utility bills, making them an economical choice for consumers.

In conclusion, the Desa EVDDVF36STN and EVDDVF36PN electric heaters embody the perfect combination of functionality, technology, safety, and style. Their dual fuel capability, rapid heating technology, and energy efficiency make them an outstanding option for anyone looking to enhance their indoor comfort while being mindful of their environmental impact.
Top Page Image Contents