INSTALLATION
FAN INSTALLATION
Your fan should only be installed once the unit is in place in order to prevent any damage to the fan.
1)Attach the Left and Right Side Fan Facia to the Front Fan Facia by aligning the Side Facia screw slots with the hole locations in the Front Fan Facia and secure using 2 screws per side.
Front Fan
Facia
Left Side Fan
Facia
Right Side
Fan Facia
Backside of Fan Facia Shown.
2)Once the Fan Facia has been assembled carefully slide the Fan into position by centering the Fan below the Ashlip and align the Fan Support Clips with the Offset Clips under the Ashlip.
Note: The Draft Control Rod is to fit through the top open- ing in the Switch Plate.
IMPORTANT
Ensure that the Left and Right Side Fan Facia do not hit the sides of the Faceplate when sliding the Fan into position as the casting may chip.
If the spacing between the Side Fan Facia and the Face- plate requires adjustment, the Side Fan Facia's can be slightly pushed in or pulled out to fit accordingly.
3)Ensure that the power cord is not in contact with any hot stove surfaces.
DO NOT ROUTE POWER CORD UNDER
OR IN FRONT OF UNIT.
Do not turn the fan ON until your insert has reached operating temperature or at least 30 minutes after starting fire.
Draft Control | Ashlip | Fan | Switch | |
Rod | Plate | |||
| ||||
| Support Clips | |||
|
|
|
12 | Hampton HI300 Wood Cast Insert |