Safety
PROPANE GAS FUEL
WARNING
Never use Natural Gas in a Grill that has been configured to burn Propane Gas, (and never use Propane Gas in a Grill that has been configured to use Natural Gas) to avoid possible bodily injury. Always consult the Rating Label on the back of the Grill to confirm that it has been configured to burn Propane Gas.
Always install the pressure regulator and Type 1 propane gas supply coupling and hose that has been provided with your Propane Grill, as pictured in Figure 2.
•Always install a standard 20 lb. propane cylinder that has been equipped with a Type I valve outlet as shown in Figure 3, and that is 12” in diameter and 18” in height. Always use a propane cylinder that has been constructed and marked in conformance
with either the specifica- |
| Check hose for breaks |
| ||
Figure 2 | or wear before each | To Main Burner Manifold | |||
tions for LP Gas Cylinders |
|
| |||
| use. |
|
|
| |
of the U.S. Department |
|
|
|
|
|
of Transportation or the |
|
|
|
|
|
specifications in the Na- |
|
|
|
|
|
tional Standard of Canada, | Type 1 Connector |
|
|
| |
|
|
| |||
|
|
|
|
| |
Spheres and Tube for Trans- |
|
|
|
|
|
portation of Dangerous |
|
|
|
|
|
Goods, as applicable. |
|
|
|
| To Side Burner |
• Always confirm that |
|
|
|
| Valve |
|
|
|
|
| |
your propane cylinder is |
|
|
|
|
|
equipped with a shutoff |
|
| Regulator | B124 | |
valve terminating in a Type |
|
| |||
|
|
|
|
| |
I propane cylinder valve |
|
|
| Figure 3 |
|
outlet connection, and that it has been provided with a collar to |
| Shutoff Valve | |||
protect the cylinder valve. |
|
|
| Collar |
|
• Never install a propane cylinder in this Grill unless it is equipped with a listed Overfill Protection Device (OPD).
•Always have a new propane cylinder properly purged of air by your certified propane gas dealer. Since a new cylinder is initially filled with air, the air must first be purged before it is filled with propane.
•Always visually inspect the gas supply line for fraying, cracking or rodent damage before each use of this Grill and, if neces- sary, install a replacement hose and regulator obtained from the manufacturer prior to lighting this Grill.
•Always place a dust cap on the cylinder valve outlet whenever the cylinder is not in use and always install the dust cap that was
provided with the cylinder valve. The use of an incorrect dust | B125 |
cap could result in leakage of propane.
Page 2
50004425