Vermont Casting VCS501 manual Warming Rack Cooking Grates

Page 13

VCS501 Series Assembly

Step 12: Install the Internal Components (continued)

Set the cooking grates, side by side, on the upper ledge of the grill tub. (Fig. 15) Make sure the finger groove is facing toward the front of the grill.

Set the warming rack into the supports located on either side of the rear lid.

CAUTION: Do not attempt to turn the cooking grates over while the grill is in use and the grates are hot. Doing so could result in severe burns and other injuries.

Figure 15

Warming Rack

Cooking

Grates

B356

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or mov- ing the grill is recommended.

30005436

13

Image 13

Contents Assembly Procedures VCS501 Series Unpack Carton and Verify Contents Parts Required Install the CastersFigures 2 Attach Skirt OptionalGrease Pan / Grease Cup Installation Kit Shelf Right Contents Kit Condiment Tray ContentsKit Shelf Left Contents Right Side Shelf Left Side ShelfSteps 4 & 5 Right & Left Side Shelf Assembly Parts Required Right Shelf Assembly Attach Right Shelf Assembly to GrillParts Required Left Shelf Assembly Attach Left Shelf Assembly to GrillSpit Rod Storage Bracket Parts Required Left Side Right SideSpit Rod Storage Brackets Install the Ignitor Battery Attach Side Burner AssemblyInstall the Backlighting Batteries Cooking Tips Smoker Box Install the Internal ComponentsWarming Rack Cooking Grates Install the LP Cylinder LP Models only Install the Natural Gas Hose Natural Gas NG Models only Cook Light #10-24 x 1/2 Screws 50000337 Figures 19, 20 Install Shelf LightVCS501 Series Assembly Mhsc