VCS501 Series Assembly
Step 2a: Install the Casters
This step requires 2 people.
Parts Required:
(4)Casters (2 with brake, rear; 2 without brake, front)
(1)Block (not included)
(16)
Figure 1
NOTE: Casters (wheels) may differ from those shown in the illustration depend- ing on the model you purchased.
Select a side to begin installing the casters. Place a block of wood, thick tele- phone book or anything else available - approximately 6 inches thick - under the side to support the weight of the barbecue. Insert the four (4) bolts attached on the casters into their respective holes located on the bottom, near the front. If you have any difficulty snapping them into place, try rotating the casters in a circular motion.
As one person holds the front caster in place, the other opens the front
door and installs four (4) flange nuts. Tighten the flange nuts on the front caster. Repeat this process with the rear caster.
When both casters are in place on one side, repeat the same procedure on the opposite side.
Rear Caster 
w/Brake
Blocking
Front Caster without Brake
Figure 1
B346
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or mov- ing the grill is recommended.
30005436