Install Shelf Light | Vermont Casting VCS501 instruction

To Open

VCS501 Series Assembly

Step 15: Install Shelf Light

Parts Required:

(1) Cook Light

(3)#10-24 x 1/2” Screws (50000337) Figures 19, 20 & 21

Attach the cook light to the side shelf using three (3) screws provided. (Fig. 19)

Battery Installation (3 “AA” alkaline batteries required, not included.)

Open the battery cap by turning the cap counterclockwise as shown in Figure 20. Insert the batteries into the battery compartment according to the layout in Figure 20. Replace battery cap.

Operating Instructions

To turn the light ON and OFF, press the ON/OFF button located on the back of the cook light. (Fig. 20)

To adjust the cook light, simply move the flexible arm as desired to achieve the best lighting for your task.

After use, allow the light and grill to cool completely. Place the light face down on the shelf after use and for storage. (Fig. 21) Replace the grill cover. If a grill cover is not used, the light should be removed when not in use as rain, snow, etc. could damage the light.

WARNING: The light may get hot when in close proximity to the grill surface. Do not touch the light lens when in opera- tion. Allow it to cool.

	WARNING: Keep the light away from flammable materials.
	CAUTION: Do not move the cook light directly over the	Flexible
	cooking area when the grill is on, as this may damage the	Flexible
	cooking area when the grill is on, as this may damage the	Arm
	cook light.	Arm
	cook light.
	NOTE: The light will not work until the batteries are installed.
	NOTE: For optimum battery life and to avoid damage to the
	light, we recommend you retract and turn off the light when not
	in use.

WARNING: Replacing the battery incorrectly might result in an explosion. Replace the battery only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to your local environmental guidelines.

Figure 19

Screws