Meco 8452-5-SS1 manual Burner REMOVAL/RE-ASSEMBLY, Foil PAN/GREASE PAN/DRIP Tray Assembly

Page 11

STEP 11) BURNER REMOVAL/RE-ASSEMBLY:

The Burners (49) are already installed in the grill. There is some cardboard packing underneath each burner; it will burn off the first time of use. If you wish to remove it:

1.Remove the burner pin. (FIG. 11A)

2.Lift the burner upwards. (FIG. 11B)

3.Gently pull the burner mouth away from the valve injector. (FIG. 11C)

4.Lift the burner out and remove the cardboard packing. (FIG. 11D)

(49)MAIN BURNER

(50)MAIN BURNER PIN

FIG. 11A

Remove Burner Pin from underneath.

FIG. 11B

Lift Burner Upwards.

View from inside Body

Injector nozzle.

FIG. 11C

Burner venturi hole

 

fits centrally around

 

the injector nozzle.

To install the burners (Follow photos in reverse order):

1.Carefully slide the burner venturi hole over the valve injector nozzle. The Burner venturi hole fits centrally around the injector nozzle.

2.Lower the burner into the body.

3.Insert the locating stud through the support.

4.Lock into place by inserting the burner pin through the stud from underneath.

FIG. 11D

Lift Burner up and out.

STEP 12) FOIL PAN/GREASE PAN/DRIP TRAY ASSEMBLY:

Insert the Foil Pan (51) into the Grease Pan (52). Slide the Grease Pan underneath into the guides of the Drip Tray (53). Slide the Drip Tray with Foil pan and Grease Pan into the bottom of the Bowl assembly. (Fig. 12) Secure Drip tray into cart with two ST4.0 x 10 mm Screws.

(13) ST4.0 x 10MM SCREW

(51) FOIL PAN

Fig. 12

(53) DRIP TRAY

(13) ST4.0 X 10MM

SCREW

ON EACH SIDE

(52) GREASE PAN

11

Image 11
Contents Ulurutm LP Gas Grill Elite Contents Assembly InstructionsParts Illustrations Parts Illustrations Cont’d Parts List Description QTYPhillips Screwdriver Pliers Or Wrench Parts List ContdPanel Brace Door Assembly Caster AssemblyHOOD/BOWL to Cart Assembly Side Burner Valve Assembly Burner Side Table AssemblySide Burner KNOB/GRID Assembly Side Burner AssemblyLift Burner up and out Burner REMOVAL/RE-ASSEMBLYFoil PAN/GREASE PAN/DRIP Tray Assembly Install the Ignition BOX Flame DIFFUSER/GRID/ Warming Rack AssemblyWiring the Ignition BOX LP Hose and Regulator CONNECTING/DISCONNECTING the GASUsing GAS LP CylinderSelecting a Location Before Using Your LP GAS GrillInstallation Codes Operating and Maintaining Your GAS GrillFrom under Control Panel How to perform a leak testRemove three screws Lighting with Ignitor Lighting the Grill Using PULSE-SPARK IgnitorYellow Tip Primarily Blue Flame Manual Lighting the Grill Lighting the Side BurnerCheck Your Flame Grill Cooking Manual Lighting the Side BurnerWarming Rack Roasting Hood CookingEND of Cooking Session Care and MaintenanceCleaning the Grill Grill Body and Cabinet Storage Problem Possible Cause SolutionBurners will not light using the ignitor Burners will not light Using a matchImportant Notice Meco Corporation Limited Warranty