STEP 9) SIDE BURNER ASSEMBLY:
Insert the Side Burner (44) and the Electrode Wire through the front of the large hole in the Side Table. (FIG. 9A) Install the burner tube end over the valve nozzle. (FIG. 9B) Secure the Burner to the bracket with two M4x8mm Screws (45). (FIG. 9B) Pass the Electrode Wire through the opening at the top left corner of Side Panel for later connection to Ignition Box. (See also Wiring the Ignition Box.)
(44) SIDE BURNER- (46) ELECTRODE WIRE
(45)M4 X 8MM
SCREW
|
|
|
|
|
| Fig. 9A |
| Fig. 9B | |
|
|
|
|
|
BURNER TUBE END INSTALLED
OVER VALVE NOZZLE
BURNER SECURED WITH
TWO M4x8mm SCREWS (45)
PASS THE ELECTRODE WIRE THROUGH THE OPENING AT THE TOP LEFT CORNER OF SIDE PANEL FOR LATER CONNECTION TO IGNITION BOX.
STEP 10) SIDE BURNER KNOB/GRID ASSEMBLY:
Align the flat keyed hole in the Control Knob (47) with the keyed stem of the valve. (FIG. 10) Push the Side Burner Knob onto the Valve stem.
Place the Side Burner Grid (48) onto the Side Burner Table letting the three protruded ends fall into the three holes in around the Side Burner.
(47) CONTROL KNOB
(48) SIDE BURNER GRID
PUSH SIDE BURNER KNOB (47) ONTO VALVE STEM
10
FIG. 10