Storage, Problem Possible Cause Solution | Meco 8452-5-SS1 instruction

STORAGE

To reduce the risk of serious bodily injury or death:

·Store your LP gas grill in a cool dry place. Do not store an LP gas cylinder in a space greater than 125 degrees Fahrenheit. Do not store an LP gas cylinder in a building ,garage or any enclosed area.

·Do not store an LP gas cylinder indoors (empty or filled). Disconnect the LP gas cylinder from the gas grill and store it outdoors out of the reach of children. The gas grill may then be stored indoors.

·To avoid an explosion, do not leave an LP gas cylinder inside a vehicle that can become overheated by the sun.

·Even though your LP gas cylinder may appear to be empty, gas may still be present and the cylinder should be transported and stored accordingly.

·Do not store a spare LP gas cylinder under or near the LP gas grill.

·Always turn off the gas cylinder at the LP cylinder valve when the gas grill is not in use.

1)Disconnect LP gas cylinder from grill and store outside, in a dry, well-ventilated area, away from any sources of heat or ignition. Re-cap LP cylinder valve with the Safety Cap.

2)Remove Burners and wrap with aluminum foil to prevent insects from entering the burner holes. Store wrapped Burners on top of cooking grid.

3)You may wrap the Cooking Grid and Flame Diffusers in aluminum foil and place inside the Hood or store inside your dwelling.

4)Place a grill cover over the grill and store the gas grill outdoors if possible. It may be stored indoors only if the cylinder or the the natural gas line is disconnected from the gas grill.

5)Before next use, remove aluminum foil and reinstall Burners, Flame Diffusers, ceramic briquette trays and Cooking Grids.

6)Before using the grill after periods of storage or non-use (i.e. over winter), check your LP gas grill for gas leaks, deterioration, proper assembly, and burner obstructions.

7)Periodically check and tighten all nuts, bolts, and screws.

TROUBLESHOOTING

Problem

Possible Cause

Solution

Burners will not light using the ignitor

Burners not assembled correctly

Not holding ignitor switch long enough for pulse spark

No spark

LP- gas cylinder is empty

LP-Coupling nut is not fully connected to regulator

LP-Excess flow valve tripped in regulator

Obstructions in burners

Electrodes and burners are wet

Wire loose or disconnected

Wire shorting (sparking between ignitor and electrode

See Burner Maintainance re-assembly after cleaning.

When lighting the 1st (Leftmost) Burner, push control knob in and turn counter-clockwise to the “High” position. Pause 4 seconds, then depress the ignitor button rapidly for 4-5 seconds to light the burner.

1-Make sure all the wires are connected and to the right terminals.

2-Check the battery. Make sure it is pushed in the holder.

3-Gas collector tab is bent (making too large or small of a gap between electrode and tab). By hand, bend gas collector tab back within a maximum of 3/16” gap to electrode. (See page 16 for illustration).

Take LP gas cylinder to licensed LP gas supplier to be refilled.

Tighten coupling nut by hand about one-half to three quarters additional turn. Do not use tools.

Turn control knobs to “off” position and turn LP gas cylinder handle clockwise until it stops. Wait five minutes. Relight LP gas grill.

Clean burners (See Burner Maintenance in Cleaning and Maintenance section of this manual)

Dry electrode with clean cloth. Air dry or use blow dryer.

Reconnect the wire.

Replace ignitor wire/electrode assembly (Call the Customer Service Department).