Flame DIFFUSER/GRID/ Warming Rack Assembly

STEP 13) FLAME DIFFUSER/GRID/ WARMING RACK ASSEMBLY:

Lay a Flame Diffuser (54) over each Burner on the lower Body ridges from front to back. Place each Flame Diffuser in the individual guides to keep from sliding. (FIG. 13A)

Place the Cooking Grids (55) over the Burner Diffusers on the upper Body ridges. (FIG. 13B)

Insert the ends of the Warming Rack (56) into the V-shape hangers at each end of the hood. (Fig. 13C)


	Fig. 13A
	Fig. 13A				Fig. 13B

(54)FLAME DIFFUSER

(55) COOKING GRID

(56) WARMING RACK


			V-SHAPE HANGER

	Fig. 13C


	9-VOLT		(57) IGNITION BOX

STEP 14) WIRING THE IGNITION BOX:

·Route the wiring through the top left side of the Crossbar to the inside of cabinet. (Fig. 14A).

·Hold the Ignition Box (57) in your hand. (Fig. 14B)

·Attach BLACK wire from Side Burner and RED and Blue wires from Main Burners to terminals 1, 2 and 3.

·Attach LARGE BLACK wires from Ignitor Switch to the pair of terminals on the LOWER right side of the Ignition Box.

·Install a 9-Volt battery with positive (+) terminal shown on Ignition Box.

ROUTE WIRING OVER TOP

CORNER OF CROSSBAR ABOVE

THE LEFT DOOR

Fig. 14A

BLACK WIRE

FROM SIDE

BURNER, RED &

GREEN WIRES TO TERMINALS 1, 2 & 3

BATTERY

LARGE BLACK WIRES

FROM IGNITOR

BUTTON

Fig. 14B

STEP 15) INSTALL THE IGNITION BOX:

Align the Ignition Box Shim (58) and Ignition Box (57) with mounting plate on inside of LEFT Side Panel. Attach the Ignition Box and Shim with two ST4.0 X 10MM Screws (13). (Fig. 14C)

This completes assembly of the grill.

(13) ST4.0 x 10MM SCREW

(58) IGNITION

BOX SHIM

(57) IGNITION BOX

(58)IGNITION BOX SHIM

(14/15) LEFT SIDE PANEL

FIG. 14C