POSITIONING GRILL ON CART
WARNING
THIS GRILL IS HEAVY! Moving, unpacking and assembly is a two person operation.
6.A. Push down wheel locking tabs on cart before setting the grill in place. Make certain that Vertical Support Struts are pulled out. Carefully lift empty Grill and place on top of Cart. Struts should be about 1- inch from side of Grill.
B.Align Bottom Vent centered between 2 Struts. Be certain that grill is centered on the support base.
C.Slide each Strut up against side of Grill and WRENCH TIGHTEN all nuts underneath the base. Repeat this on each Strut.
BEFORE | A | B AFTER |
C
Pull Out | Center Bottom | ||
|
|
| Vent between |
|
|
| |
|
|
| Struts |
| Struts pulled out before | Assembled View | |
| placing grill on base. |
| |
Push In
Slide struts in to touch side of grill. Wrench tighten all nuts underneath.
INTERNAL SET UP FOR COOKING
After setting grill on the cart; First, place Fire Bowl into Bottom Grill Body, be sure that the rectangle opening is facing the Vent Opening. Second, make sure Fire Bowl is stable and DOES NOT wobble back and forth. If there is a wobble, then insert one or both wedge shaped stabilizers under the Fire Bowl to decrease wobble. Third, set Charcoal Plate inside Fire Bowl. Fourth, place Insulation Ring so that it rests on Fire Bowl. Fifth, place Cooking Grate on top of Insulation Ring.
| Fire Bowl | Fire Bowl Stabilizers (if needed) | Charcoal Plate |
1 | 2 |
| 3 |
Insulation Ring | Grate |
45
7
NOTE: FIRE BOWL STABILIZERS
Sometimes the Fire Bowl will not set perfectly stable when placed inside the grill. It may rock from
Should this occur, locate the "gap" where it wobbles. Then insert the wedge shape stabilizer into that gap. It may be necessary to partially lift the Fire bowl as you insert the wedge.
Two wedge stabilizers are provided. You may need one, two, or none; you decide.