Char-Broil 7201560 owner manual Do not fully tighten screws until is complete

Page 3

FIRST, GET A HELPER! This unit is heavy and requires a second person for lifting and moving. NEXT, pick a suitable

1 location to work. Open the carton and slit the corners so that the carton lays flat. This will give you a protective work surface during assembly.

TO BEGIN ASSEMBLY, build two leg assemblies by sliding the long leg sections into the short leg sections.

Short leg section

Long leg section

2

Attach leg braces to the outside of one leg assembly using #10-24x1-3/4” screws and #10-24 flange nuts. Make sure

slotted (oval) hole is toward bottom of leg. DO NOT FULLY TIGHTEN screws until Step 6 is complete.

Leg brace

Leg brace

Do not fully tighten screws until Step 6 is complete.

Slotted

hole

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Smoker, BBQ and Grill Center Operation are 800 A.M. To 600 P.M. EST Monday Friday No need to go back to the storeDo not fully tighten screws until is complete Upward, parallel to leg braces For clarity Fully Tighten ALL Screws and Nuts AT This TimeAre included with ignitor Bolts as shown belowInside Do not fully tighten until Step Slat Screws If you have purchased the optional 3 Temperature GaugeGrease Clip Grate Support Screws Large Porcelain Cooking Grate Small Porcelain Cooking Grate Hardware List Preparing and Using Your Silver Smoker Limited Warranty Char-Broil, LLC Columbus, GA 31904 Assembly Instructions
Top Page Image Contents