Char-Broil 7201560 owner manual Fully Tighten ALL Screws and Nuts AT This Time, For clarity

Page 5

Insert a cotter pin into the hole at one end of the axle and bend the ends of the pin back so that it cannot be removed. Slide

5 a wheel onto the axle. Slide the axle through the holes at the ends of the short legs. Slide remaining wheel onto axle and secure with remaining cotter pin.

Cotter pin

Axle

Cotter pin

6

NOTE: Smoker chamber door not pictured

for clarity.

Stand the leg assembly on end, wheels down. Stand the smoker chamber on its solid end, open end up. Place leg assembly against chamber, aligning holes in legs with holes in chamber. Attach legs to chamber using four 1/4-20x2” screws and 1/4-20 flange nuts. Insert screws from outside, flange nuts inside chamber.

FULLY TIGHTEN ALL

SCREWS AND NUTS AT

THIS TIME.

Open end up

Smoker chamber

Wheels down

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Smoker, BBQ and Grill Center Operation are 800 A.M. To 600 P.M. EST Monday Friday No need to go back to the storeDo not fully tighten screws until is complete Upward, parallel to leg braces For clarity Fully Tighten ALL Screws and Nuts AT This TimeAre included with ignitor Bolts as shown belowInside Do not fully tighten until Step Slat Screws If you have purchased the optional 3 Temperature GaugeGrease Clip Grate Support Screws Large Porcelain Cooking Grate Small Porcelain Cooking Grate Hardware List Preparing and Using Your Silver Smoker Limited Warranty Char-Broil, LLC Columbus, GA 31904 Assembly Instructions
Top Page Image Contents