Char-Broil 7201560 owner manual Bolts as shown below, Are included with ignitor

Page 6

7

Attach Firebox Top Assembly to Firebox Bottom Assembly using eight 1/4-20x3/4”hex-head

bolts as shown below.

Firebox Top Assembly

Firebox Bottom Assembly

8

NOTE: Smoker chamber and firebox doors not pictured for clarity.

 

Diamond FireTM Plate Installation - For models without Diamond FireTM ignitor accessory,

part number 22504850.

 

 

TM

 

 

For models that feature the Diamond Fire ignitor accessory, supplemental instructions

 

are included with ignitor.

 

 

First, locate the cover plate in the hardware box. At the bottom right end of the

Firebox

 

firebox there is an opening for the Diamond FireTM ignitor accessory. Install the

cover plate over the opening using two #8-32x1/2” screws and #8-32 lock nuts. Second, align the hole pattern on the firebox with the pattern on the

smoker chamber. The firebox should be slightly offset from the smoker chamber. Attach using six 1/4-20x3/4”hex-head bolts and flat washer inside firebox and 1/4-20 flange nuts inside smoker chamber.

Firebox

Cover Plate

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Smoker, BBQ and Grill No need to go back to the store Center Operation are 800 A.M. To 600 P.M. EST Monday FridayDo not fully tighten screws until is complete Upward, parallel to leg braces Fully Tighten ALL Screws and Nuts AT This Time For clarityBolts as shown below Are included with ignitorInside Do not fully tighten until Step If you have purchased the optional 3 Temperature Gauge Slat ScrewsGrease Clip Grate Support Screws Large Porcelain Cooking Grate Small Porcelain Cooking Grate Hardware List Preparing and Using Your Silver Smoker Limited Warranty Char-Broil, LLC Columbus, GA 31904 Assembly Instructions
Top Page Image Contents