![](/images/new-backgrounds/1136909/13690955x1.webp)
Troubleshooting (continued)
Problem | Possible Cause | Prevention/Solution | |
|
|
| |
Burner(s) will not light | ELECTRONIC IGNITION: | • See Section I of Electronic Ignition System. | |
using ignitor. | • No spark, no ignition noise. | ||
(See Electronic Ignition | • No spark, some ignition noise. | • See Section II of Electronic Ignition System. | |
Troubleshooting also) | |||
| • Sparks, but not at electrode or at full | • See Section III of Electronic Ignition System. | |
| strength. |
| |
Burner(s) will not | • See “GAS ISSUES:” on previous page. |
| |
match light. | • Match will not reach. | • Use | |
| |||
| • Improper method of | • See | |
Sudden drop in gas | • Out of gas. | • Check for gas in LP cylinder. | |
flow or low flame. | • Excess flow valve tripped. | • Turn off knobs, wait 30 seconds and light grill. If flames are still low, | |
| |||
|
| turn off knobs and LP cylinder valve. Disconnect regulator. | |
|
| Reconnect regulator and | |
|
| 30 seconds and then light grill. | |
| • Vapor lock at coupling nut/LP cylinder | • Turn off knobs and LP cylinder valve. Disconnect coupling nut from | |
| connection. | cylinder. Reconnect and retry. | |
Flames blow out. | • High or gusting winds. | • Turn front of grill to face wind or increase flame height. | |
| • Low on LP gas. | • Refill LP cylinder. | |
| • Excess flow valve tripped. | • Refer to “Sudden drop in gas flow” above. | |
• Grease buildup. | • Clean burners and inside of grill/firebox. | ||
| • Excessive fat in meat. | • Trim fat from meat before grilling. | |
| • Excessive cooking temperature. | • Adjust (lower) temperature accordingly. | |
|
|
| |
Persistent grease fire. | • Grease trapped by food buildup around | • Turn knobs to OFF. Turn gas off at LP cylinder. Leave lid in position | |
| burner system. | and let fire burn out. After grill cools, remove and clean all parts. | |
|
|
| |
Flashback... | • Burner and/or burner tubes are blocked. | • Turn knobs to OFF. Clean burner and/or burner tubes. See burner | |
(fire in burner tube(s)). |
| cleaning section of Use and Care. | |
Unable to fill LP | • Some dealers have older fill nozzles | • The worn nozzles don’t have enough “bite” to engage the valve. Try | |
cylinder. | with worn threads. | a second LP dealer. | |
One burner does not | • Grease buildup or food particles in | • Clean | |
light from other | end(s) of carryover tube(s). |
| |
burner(s). |
|
| |
| Possible Cause | Prevention/Solution | |
(If Equipped) | |||
|
| ||
Timer does not work | Dead Battery | Replace batteries | |
(Green light does not | Batteries installed incorrectly. | Install batteries correctly. | |
flash) | Knob Position did not start the Clean | Push Knob in to start the clean cycle. (Green LED should begin to | |
| Cycle | flash) | |
|
|
| |
No LED’s will illuminate | Dead Battery | Replace batteries | |
|
|
| |
Red LED next to battery | Low Battery Strength | Prepare to replace batteries (NOTE: Clean cycle will operate with | |
symbol is illuminated |
| a weak battery. | |
|
|
|
28