DISCHARGE TUBE INSTALLATION
Landlord/1700 Series (Mfg. No. 1692526) Broadmoor/1600 Series (Mfg. No. 1692526)
1.Install the spring clip (D, Figure 26) with two 10/32 x 1/2 truss head screws (E), four flat washers (F), and two locknuts (G).
2.Install
3.Position the lower tube (C) onto turbo housing and hook inside spring clip onto flange locknut (I, installed in step 2). Mark hole location on opposite side of turbo housing for outer spring clip.
4.Remove lower tube and drill 9/32 hole in turbo hous- ing and install
5.Assemble the upper tube (A) on to middle tube (B) as shown in Figure 2 with two 10/32 x 1/2 truss head screws (E), four flat washer (F), and two locknuts (G).
6.Install two 10/32 x 1/2 truss head screws (E), four flat washer (F), and two locknuts (G) to the top holes in the lower tube (C). Leave hardware loose.
7.Install upper tubes (A and B) to lower tube (C) and tighten hardware.
8.Install tube assembly into cart sleeve and onto turbo housing. Hook spring clips (D) onto flange locknuts (I) installed on turbo housing.
SunStar/1900 Series (Mfg. No. 1691526) Sovereign/900 Series (Mfg. No. 16911526)
1.Assemble the tube (A, Figure 27) to hose (B) with four 10/32 x 1/2 truss head Phillips screws (C) installed from inside hose. Secure on outside of tube with #10 flat washers (D) and 10/32 locknuts (E).
2.Install hose (B) onto turbo housing and secure with hose clamp (F).
3.Install the tube assembly into the connecting sleeve of the cart.
Discharge Tube Installation
A
B
C
D
E
F
G
Figure 27. Discharge Tube Installation
A. Decal | E. Truss Head Screw |
B. Discharge Tube | F. Hose |
C. Locknut, Hose | G. Clamp |
D. Washer |
|
11