Simplicity Turbo Wide Body Cart & Hitch manual Cart Assembly

Page 8

Cart Assembly

Figure 8. Wheel Assembly

 

A. Wheel Assembly

B. Frame

CART ASSEMBLY

1.Install the wheel assemblies (A, Figure 8) to the frame (B). Place the head of the swivel wheel on the end of the frame. Align the holes and place four 3/8- 16 x 1 hex bolts up through the frame and head of the swivel. Secure with four flat washers (13/32 I.D., 7/8 O.D.) and 3/8-16 locknuts.

2.Install the U-bracket (A, Figure 9) to the bottom of the box (B). Place the three 5/16-20 x 3/4 slotted truss head bolts and three flat washers (11/32 I.D., 3/4 O.D.) through the inside of the box and the U-brack- et. Secure with three 5/16 lockwashers and nuts.

3.Turn box upside down and install the frame to the U bracket (Figure 10). Align the two prong end (A) in the frame with the ends of the U-bracket and secure with two 1/2-13 x 1-1/4 hex bolts and locknuts. DO NOT over-tighten the locknuts, since the box pivots at this point for dumping.

Note: The latch handle (A, Figure 11) is located on the right hand side on cart, Mfg. No. 1691526 and on the left hand side on cart, Mfg. No. 1692526.

4.Turn box with frame upright and install the latch han- dle (A, Figure 11) and two lift handles (B) as follows:

a.Latch Handle: Place one 5/16-18 x 1 hex bolt with 5/16 spring washer through the inside of the box. Next place a 5/16 flat washer over the bolt on the out- side of the box, the latch handle, a 5/16 flat washer, a 5/16 spring washer and a 5/16 nut and jam nut. Tighten the nuts so that when the latch handle turns the bolt and nut will not turn. (Be sure the cups of the spring washers are facing toward the box surface on both sides.)

b.Lift Handles: Install the two lift handles on the out- side of the box. Place two 1/4-20 x 1/2 slotted truss head bolts through the inside of the box and the lift handle. Secure with two 1/4 lockwashers and nuts.

Figure 9. Install U-Bracket

 

A. U-Bracket

B. Box

Figure 10. Install Frame

A. Prong End

Figure 11. Install Latch Handle

A. Latch Handle

B. Lift Handle

6

Image 8
Contents OPERATOR’S Manual Page Table of Contents SpecificationsIllustrations & Part Lists CoverIllustrations & Part Lists Tube Assembly Landlord & Broadmoor Safety Rules Safety RulesCart Assembly Cart AssemblyCover Assembly Cover AssemblyInstall Connecting Sleeve Hitch Installation Hitch InstallationSunStar/1900 Series Mfg. No Sovereign/900 Series Mfg. NoHitch Assembly Broadmoor Broadmoor/1600 Series Mfg. NoDischarge Tube Installation Discharge Tube InstallationLandlord/1700 Series Mfg. No Broadmoor/1600 Series Mfg. No SunStar/1900 Series Mfg. No Sovereign/900 Series Mfg. NoMaintenance Connecting Cart / MaintenanceConnecting Cart to Tractor Operation OperationBefore Operation During OperationReinstallation After Removal Operating Without Collection SystemHardware Identification & Torque Specifications