Simplicity Turbo Wide Body Cart & Hitch manual Operating Without Collection System

Page 16

Operation

Operating Without Collection System

WARNING

To operate without the collection system, the blower assembly must be removed and the deflector must be in down position.

1.Unhook the cart from the tractor by removing two cle- vis pins and spring clips (Figure 28).

2.To remove the blower, remove the belt from the pul- ley (A, Figure 31).

3.Close cover (D) and tighten knob.

4.Loosen wing nut (B) and, while holding deflector (C) up, pull blower off mover.

WARNING

The deflector is spring loaded. When removing the blower, hold the deflector up. Then allow the deflector to go down into normal operating posi- tion (see Figure 33).

5.Allow deflector to go down into position shown in Figure 32.

NOTE: For easier belt removal, later model blowers have a wire loop to move spring-loaded idler pulley.

Reinstallation After Removal

Raise the deflector to slide the blower into position. Tighten the wing nut (B, Figure 31). Place the belt onto the pulley (A) and close the cover (D) and tighten knob. Connect cart and chute.

Figure 31. Removing the Blower

A.

Pulley

C. Deflector

B.

Wing Nut

D. Cover

 

 

 

 

 

 

Figure 32. Deflector

14

Image 16 Contents
OPERATOR’S Manual Page Table of Contents SpecificationsIllustrations & Part Lists CoverIllustrations & Part Lists Tube Assembly Landlord & Broadmoor Safety Rules Safety RulesCart Assembly Cart AssemblyCover Assembly Cover AssemblyInstall Connecting Sleeve Hitch Installation Hitch InstallationSunStar/1900 Series Mfg. No Sovereign/900 Series Mfg. NoHitch Assembly Broadmoor Broadmoor/1600 Series Mfg. NoDischarge Tube Installation Discharge Tube InstallationLandlord/1700 Series Mfg. No Broadmoor/1600 Series Mfg. No SunStar/1900 Series Mfg. No Sovereign/900 Series Mfg. NoConnecting Cart to Tractor Connecting Cart / MaintenanceMaintenance Operation OperationBefore Operation During OperationReinstallation After Removal Operating Without Collection SystemHardware Identification & Torque Specifications
Related manuals
Manual 18 pages 18.05 Kb