7
FINISHING
LOG PLACEMENT
PHAZERTM logs are exclusive to NAPOLEON® Fireplaces, and provide a unique and realistic glowing effect that is dif- ferent in every installation.
Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
FIGURE 11a-d
3.Place the bottom of the left crossover log (#4) against the left firebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
SIDEVIEW
TAB 
1.Place the back log (#1) onto the log support tray and in front of the tabs. The tabs maintain an air space between the log and firebox back to facilitate combus- tion air flow. Ensure that the back of the log rests against the brackets on the back wall of the firebox.
4.Position the notch located on the end of the center log (#5) against the middle grate post with the other end of the log resting in the pocket of the left crossover log.
5.Place the bottom of the right crossover log (#6) against the right firebox side and pulled forward to the grate. The top of the log should rest in the pocket provided on the center log (#5).
2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs. Ensure that the small logs sit flat on the burner.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame.PHAZERTM logs available from your NAPOLEON® dealer.
IMPORTANT
IT IS HIGHLY RECOMMENDED TO PROTECT
THE LOGS FROM MOISTURE.
COVER THE FIREBOX WHEN NOT IN USE.