Leak Testing Instructions

BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this connector to the flare fitting on the end of the manifold. Connect the other end of the connector to the gas piping. Ensure that the connector does not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use a hose to connect the unit. It must be connected with rigid pipe, copper tube or an approved flexible metal connector which complies with Z21.4 /CSA 6.10. The installation must comply with CAN B149.1 Natural Gas and Propane Installation Code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply pipe must be sufficiently sized to supply the BTU/h specified on the rating plate, based on the length of the piping run. If installing a side burner, a separate line must be branched off to the side burner unit and enter the side burner opening at the specified location.

WARNING! Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires, the pan must be cleaned after each use.

WARNING! Access must be provided to the inside of the enclosure to make gas connections.

DANGER! Read all instructions carefully before operating the grill. Failure to follow these instructions exactly could result in a fire causing serious injury or death. The entire installation must be leak tested before operating the grill.

WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced.

Warning! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury, or death.

Leak testing: This must be done before initial use, annually, and whenever any gas components are replaced or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check. Turn all burner controls to the off position. Turn gas supply valve on.

Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and valves.

Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommended by the Napoleon Customer Care department and have the grill inspected by a certified gas installer.

If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill inspected by a certified gas installer or dealer. Do not use the grill until the leak has been corrected.

www.napoleongrills.com

BIPRO 450 specifications

The Napoleon Grills BIPRO 450 is a standout choice for grilling enthusiasts who seek the perfect blend of style, functionality, and performance. Boasting a range of innovative technologies, this grill is designed for both novice and experienced chefs, bringing restaurant-quality grilling right to your backyard.

One of the most prominent features of the BIPRO 450 is its generous cooking area, offering an impressive 450 square inches of primary cooking space. This ample area allows you to prepare multiple dishes simultaneously, making it an exceptional option for family gatherings or outdoor parties. Moreover, the grill comes with a durable stainless steel cooking grid that not only promotes even heat distribution but is also easy to clean, ensuring hassle-free maintenance.

The Napoleon BIPRO 450 includes advanced infrared technology, which is integrated into its rear burner. This allows for high-temperature cooking and the ability to achieve perfectly seared meats. The infrared heat penetrates quickly, locking in the juices of your food and delivering outstanding flavor. Additionally, the grill is equipped with a built-in smoker box, allowing you to infuse your dishes with rich, smoky flavors, elevating your grilling experience to new heights.

Another standout aspect of the BIPRO 450 is its design. The grill features a sleek, built-in construction that can easily fit into an outdoor kitchen setup. Its elegant stainless steel finish not only offers a modern aesthetic but also ensures durability against the elements. The integrated LED controls offer stylish illumination, enabling easy monitoring of your grilling even at night.

The BIPRO 450 also excels in versatility, as it includes multiple burners with the capability to create various temperature zones. This feature allows you to cook different foods at the same time, catering to diverse tastes and preferences. Furthermore, the grill's ignition system is both reliable and easy to use, ensuring quick starts whenever you're ready to grill.

Safety is also a top priority, and the Napoleon BIPRO 450 includes heat-resistant handles and a well-insulated lid to keep grilling safe and comfortable.

In summary, the Napoleon Grills BIPRO 450 is a high-performance grill that combines advanced technology and thoughtful design. With its large cooking area, infrared capabilities, elegant appearance, and versatile functionality, it is an ideal investment for anyone looking to enhance their outdoor culinary adventures.