KitchenAid KBGS274SSS0 Using your Outdoor Grill, Lighting the grill, Prepare the gas supply

Page 11

OUTDOOR GRILL USE

Using your Outdoor Grill

WARNING

Explosion Hazard

Do not store fuel tank in a garage or indoors.

Do not store grill with fuel tank in a garage or indoors.

Failure to follow these instructions can result in death, explosion, or fire.

WARNING

Fire Hazard

Do not use grill near combustible materials. Do not store combustible materials near grill. Doing so can result in death or fire.

WARNING

Food Poisoning Hazard

Do not let food sit on grill for more than one hour before or after cooking.

Doing so can result in food poisoning or sickness.

2.For outdoor grills using gas supply source other than L.P. gas cylinder:

Turn the shut off valve to open position from the front of gas supply line.

Lighting the grill

grill burner

control knob

rotisserie burner

ignitor

control knob

battery

 

grill burner

control knob

1.Do not lean over the grill.

2.Select the burner you want to lite and push the grill burner control knob in. Turn the knob to “LITE/HI” while continuing to hold it in.

3.You will hear the “snapping” sound of the spark. When burner is lit, release the knob. Turn knob to desired setting.

Repeat for each of the other burners as needed.

IMPORTANT:

If burner does not light immediately, turn the burner knob to “OFF” and wait 5 minutes before relighting.

Manually lighting main grill burners

1.Do not lean over the grill.

2.Remove the manual lighting extension from inside the drip tray.

3.Attach a match to the clip.

4.Strike the match to light it.

5. Guide the lit match between the grill grate and one of the slots in the sear plate.

Prepare the gas supply

1. Open the hood completely. Do not light burners with the hood closed.

2.Make sure control knobs are turned to OFF. The drip pan must be in place and pushed all the way to the back.

drip pan

Turn the gas supply on:

1.For outdoor grills using an L.P./ propane gas cylinder: Slowly open the cylinder valve; do not “snap” open.

NOTE: If flow limiting device does activate, your grill may not light. If your grill does light, the flames will be low and will not heat properly. Turn cylinder valve and all control knobs off and wait 30 seconds. After shutting off the cylinder, very slowly open cylinder valve and wait 5 seconds before lighting.

6.Push in and turn the burner knob to “LITE/HI” for the burner closest to the lit match. The burner will light immediately. When burner is lit, turn knob to desired setting.

7.Repeat steps 3 through 6 for each main burner.

8.Remove match and replace manual lighting extension inside the drip tray.

IMPORTANT:

If burner does not light immediately, turn the burner knob to “OFF” and wait 5 minutes before relighting.

If any burners do not light after attempting to manually light them, contact the KitchenAid Customer Experience Center.

11

Image 11
Contents Installation Instructions USE and Care Guide Outdoor Grill Safety Important Safety Instructions Tools and Parts Installation RequirementsInsulated Jacket Product DimensionsLocation Requirements RotisserieRecommended ground method Electrical RequirementsBuilt-In Outdoor Grills Gas Supply RequirementsNatural Gas Use Built-In Outdoor Grill InstallationBuilt-In ArchitectTM Series Outdoor Grill Assemble Cooking Area If Converted to L.P. GasLow flame adjustment Check and Adjust the BurnersSear burner flame characteristics Adjusting the air shuttersPrepare the gas supply Using your Outdoor GrillLighting the grill Manually lighting main grill burnersManually lighting rotisserie burner Using the RotisserieLighting the rotisserie burner Cooking Methods Indirect Grillingl ing ChartchartHI/OFF/HI Trussing Poultry for the Rotisserie Rotisserie ChartRotisserie Cooking Tips Cleaning Rotisserie spit rod and forks Interior Control panel graphicsShaped burners Rotisserie spit rod handleKitchenaid GAS Grill Warranty Requesting Assistance or Service