22
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36DA(SA) and BL36DHA(SA)
Wall Switch Installation
Optional Remote Control Installation
FIREPLACE INSTALLATION
Continued
INSTALLING BRICK LINER MODELS BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.
You may purchase brick liner from your local retailer or see Ac- cessories, page 34.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.
1.Remove top and bottom louvers to allow access to door latches.
2.Unlock door latches and open glass door. See Removing Glass Door, steps 1 and 2, page 21.
3.Carefully remove lava rock and ember material. Remove log/grate assembly by unscrewing grate from plenum. The two logs under the grate are attached to burner. DO NOT attempt to remove.
4.Remove screws that attach plenum to burner to remove plenum.
5.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
6.Install rear brick panel first. Rest bottom edge of panel on back edge of burner assembly (see Figure 39).
7.Install left side brick panel by sliding it between the burner assembly and the side of the firebox (see Figure 39).
8.Install the right brick panel using the same method described in step 6 for left brick panel.
9.Replace deflector shield using screws removed in step 4.
10.Using scews removed in step 4, replace plenum and attach to burner.
11.Using screws removed in step 3, replace log/grate assembly. Be care- ful when replacing log/grate assembly not to chip logs on burner.
12.Install lava rock and glowing embers. See Installing Lava Rock and Glowing Embers, page 21.
13.Close glass door and lock latches on top and bottom of door and replace screen. See Removing Glass Door, steps 5 and 6, page 21.
14.Close top and bottom louvers.
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless
1.Open lower louver panel.
2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 40).
3.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 41). The battery is included
4.Once the battery is activated the unit is ready to use.
5.Close lower louver panel.
Fireplace
Receptacle
Remote Control
Receiver
Left Side
Brick Panel
Rear Brick
Panel
Figure 39 - Installing Rear Brick Panel
Extension Cord | Ignition | |
Module Plug | ||
|
Figure 40 - Installing the WRC Remote Receiver
Battery Cover
12 Volt Battery
Back of
HandsetPull to Remove
Insulation Tab
Figure 41 - Installing Battery into Back of Handset
www.desatech.com |