WIRING DIAGRAM
OPERATING FIREPLACE
For Your Safety Read Before Lighting Lighting Instructions
23
WIRING DIAGRAM
PILOT
IGNITOR LEAD
ORANGE
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation of new heater, burn- ing logs will give off a
|
|
| BLUE |
| 1. | STOP! Read the safety information, column 1. |
| |
|
|
|
|
|
| |||
| E12 | SYNETEK CONTROLS IS1070B | TRANSFORMER |
| 2. | Turn off all electric power to the appliance. |
| |
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||
|
| WHITE |
| 3. | Turn wall switch to the OFF position. |
| ||
EV1 | E8 | 24V AC | 120V AC |
| ||||
| E6 | 4. | Open lower louver panel. |
| ||||
| E4 | to the OFF | ||||||
| 5. | Turn equipment shutoff valve clockwise | ||||||
| E3 | |||||||
| E2 | |||||||
|
| INC | BLACK |
|
| position (see Figure 42). Do not force. |
| |
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||
|
|
| GROUND |
| 6. | Wait five (5) minutes to clear out any gas. Then smell for | ||
EV2 |
|
| RED |
| ||||
|
|
|
| gas, including near the floor. If you smell gas, STOP! Fol- | ||||
|
|
|
|
| ||||
| GREEN |
|
|
|
| |||
|
|
|
|
| low “B” in the safety information in column 1. If you donʼt | |||
|
|
|
|
|
| |||
|
|
|
|
|
| smell gas, go to the next step. | to | |
|
|
|
|
| 7. | Turn equipment shutoff valve counterclockwise | ||
OPERATING FIREPLACE |
|
| the ON position. Do not force. |
| ||||
| 8. | Close lower louver panel. |
| |||||
| 9. | Turn on all electric power to the appliance. |
| |||||
| FOR YOUR SAFETY |
|
|
| ||||
|
|
| 10. | Turn the wall switch to the ON position. |
| |||
| READ BEFORE LIGHTING |
|
| |||||
|
| 11. | Visually locate the pilot. The ignitor should begin to spark and | |||||
|
|
|
|
| ||||
WARNING: If you do not follow these instructions |
| the main burner should ignite once flame appears at pilot. | ||||||
| • | If lighting the appliance for the first time each season, | ||||||
exactly, a fire or explosion may result causing property |
| |||||||
|
| it may take several attempts before the supply gas can | ||||||
damage, personal injury or loss of life. |
|
|
|
| ||||
|
|
|
| reach the pilot and main burners. |
| |||
|
|
|
|
|
| • |
| |
A. This appliance is equipped with an ignition device which |
| If the appliance will not stay lit after several attempts, | ||||||
|
| follow the instructions To Turn Off Gas To Appliance, page | ||||||
automatically lights the pilot. Do not try to light the pilot |
|
| ||||||
|
| 24, and call your service technician or gas supplier. | ||||||
by hand. |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.
•If you cannot reach your gas supplier, call the fire department.
C. | Do not use this appliance if any part has been under water. |
| Immediately call a qualified service technician to inspect |
| the appliance and to replace any part of the control system |
| and any gas control which has been under water. |
Equipment | Pilot | |
Adjustment | ||
Shutoff | ||
Screw | ||
Valve | ||
|
Figure 42 - Turning Equipment Shutoff Valve to the OFF Position
www.desatech.com |