Assembly, Assembling Fireplace, Installing Log

CGCF26TPA

VENT-FREE COMPACT FIREPLACE

ASSEMBLY

WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive tempera- tures on fireplace surfaces.

ASSEMBLING FIREPLACE

Tools Required:

•Phillips screwdriver

•5/16" hex wrench

•slotted screwdriver

Installing Log

1.Remove back log, branch, and hood from log box. Discard protective packaging.

2.Remove two shipping screws above screen (see Figure 2).

3.Lift screen up and pull out to remove.

4.An optional blower is available. See Ac- cessories, page 22. Install optional blower now. Follow installation in- structions provided with blower.

		Screen
	Back Log	Shipping
	Back Log	Screw
		Screw

Shoulder Screw

Burner

Support

Screw

Branch

Support

Screw

Screen

Figure 2 - Assembling Fireplace

5.Gently place back log on burner sup- port (see Figure 2). The log should fit flat against top of burner support. Place two #10 one-inch-long screws through burner support into the log and tighten. Place branches on branch support (see Figure 2).

6.Reattach screen by placing notches in screen frame over shoulder screws and pushing down.

Assembling Hood

1.Locate four #10-3/8" black phillips sheet metal screws from the hardware packet.

2.Remove two 13/4" screws from under- neath middle rail (see Figure 3).

3.Slip top of hood between middle rail and top of firebox wrapper (see Figure 3).

4.Reinstall two 13/4" screws removed in step 2. Make sure screw pass through hood and middle rail and attach into upper louver assembly (see Figure 3).

5.Attach four #10-3/8" hood screws as shown in Figure 3.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in prop- erty damage or personal injury.

Middle Rail

Firebox

Wrapper

Hood

#10-3/8" Screws

Figure 3 - Assembling Hood

104278