OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL WIRELESS
NOTICE: Use only alkaline bat- teries (not included).
Installing 9-Volt Alkaline Battery into Receiver
1. | Open bottom louver and locate the |
| switch bracket on the left. |
2. | Unscrew the switch bracket. Lean |
| bracket forward so you are able to ac- |
| cess the back of the remote receiver. |
3. | Locate the battery clip mounted on the |
| back of the receiver. Slide a |
| kaline battery (not included) through |
| the clip (see Figure 39). |
Installing
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to a
3.Replace battery cover onto remote con- trol unit.
Terminal Battery
Wires Cover Remote Control Unit
Battery
Housing
Figure 41 - Installing Alkaline Battery in Hand-Held Remote Control Unit
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install optional brickliners,logs,lavarock,andembermaterial.
CAUTION: Do not operate this fireplace with a broken glass door panel. Do not operate this fire- place without the glass door panel securely in place. For replace- ment part information see Re- placement Parts, page 30.
1.Remove the upper louver panel by lift- ing upward and out (see Figure 42).
2.Remove the screws from the three tabs at the top of the glass door while holding door securely keeping it from falling forward.
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 43).
4.To replace glass door, follow the above instructions in reverse.
4. | Attach the terminal wires to the battery. |
5. | Connect wire leads to TH and THTP to |
| control valve (see Figure 40). |
6. | Replace the switch bracket. |
Receiver
Terminal
Wires
Battery Clip
Battery
Figure 39 - Attaching Alkaline Battery to Receiver
To Remote
Accessory
Figure40 -ConnectingRemoteAccessories to Control Valve
INSTALLING OPTIONAL WALL MOUNT SWITCH GWMS2
NOTICE: The GWMS2 includes 25' of wire for installation. Your fireplace includes 15' of wire for accessory installation. Choose the length that best fits your needs when installing this accessory.
1.Connect one terminal of the provided wire for the wall switch to the TPTH terminal on the valve. Connect remain- ing wire terminal to the TH terminal on the valve. Make sure that the wire terminals are in the positions on the unit as pictured in Figure 40. If wires are not connected as shown the switch will not work.
2.Route the wire through openings pro- vided on the sides of the fireplace to a convenient location to mount your switch.
3.Connect one bare wire end to each of the terminals of the GWMS2 wall switch.
4.Install the wall switch and cover in the wall.
Top Louver
Panel
Figure 42 - Removing Top Louver Panel
Glass Door
Assembly
Screw
Lower Bracket for Glass Door Assembly
Figure 43 -Removing/ReplacingGlassDoor
Continued
106424 | 21 |