Broan 42H-B For Your Safety Read Before Lighting Lighting Instructions, Lighting the Appliance

Page 20

B. Lighting the Appliance

Intellifire Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING INSTRUCTIONS

1.

Turn off wall switch.

2.

This appliance is equipped with an igni-

A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burner. Do not try to light the burner by hand.

B. BEFORE LIGHTING, smell all

around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas sup- plier, call the fire department.

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

tion device which automatically lights the

burner. Do not try to light the burner by

hand.

GAS

VALVE

3. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the

floor. If you smell gas, STOP! Follow “B”

in the Safety Information located on the left

side of this label. If you don’t smell gas,

go to next step.

WARNING: CAUTION:

4. Turn on wall switch.

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam- age. Refer to the owner’s infor- mation manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause cancer, birth defects, or other reproductive harm.

Keep burner and control compart- ment clean. See installation and operating instructions accompanying appliance.

Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.

Do not operate the appliance with panel(s) removed, cracked or bro- ken. Replacement of the panel(s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and pro- pane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the al- ternate fuel.

5.

To light the burner, flip the ON/OFF

 

switch to the “ON” position. (The ON/OFF

 

switch may include a wall switch if so

 

equipped).

6.

If the appliance will not operate, check

 

battery then follow the instructions “To

 

Turn Off Gas to Appliance” and call your

 

service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.Turn off all electric power to the appliance if service is to be performed.

2.Flip ON/OFF switch to the “OFF” posi- tion.

Final Inspection by _________________________________

20

Heat & Glo LifeStyle Collection • Dakota 42-B/Dakota 42H-B4036-909 Rev D • 08/06

Image 20
Contents This appliance must be installed outside What to do if you smell gasCongratulations Listing Label Information/LocationTable of Contents High Altitude Installations Listing and Code ApprovalsAppliance Certification Glass SpecificationsDesign and Installation Considerations Getting Started¨ Moisture Resistance Tools and Supplies NeededFraming and Clearances Select Appliance LocationFire Risk Fire Risk Odor RiskClearances Mantel ProjectionsTermination Locations Vent Termination Minimum ClearancesSecuring and Leveling Appliance Appliance PreparationRemove Logs and Shipping Cover Gas Information Fuel Conversion Gas ConnectionGas Pressure Fire Risk Explosion RiskFire Risk Explosion Risk Asphyxiation Risk Valve Access Lift Out DoorsRecommendation for Wire Intellifire Ignition System Wiring Connecting to the ApplianceElectrical Information Shock Risk Explosion RiskFinishing FireplaceNoncombustible Facing Diagram Facing MaterialAppliance Setup Clean the ApplianceGrate Assembly Placement Positioning the LogsFront Left Log SRV722 Glass Assembly Placing Lava RockFire Risk Burn Risk Operating InstructionsBefore Lighting Appliance For Your Safety Read Before Lighting Lighting Instructions Lighting the ApplianceFrequently Asked Questions Fire Risk High TemperaturesIssue Solutions After the Appliance is LitIntellifire Ignition System TroubleshootingSymptom Possible Causes Corrective Actions Maintaining and Servicing the Appliance Valve Service and Replacement Tools RequiredGround Wire Maintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference Materials¨ B. Service Parts List DAKOTA42-B SeriesDescription of Part Replaced by SRV4036-260 Pre Serial #OD9288 Battery Pack 593-594A Also availableSRV727 SRV720 SRV723 SRV722 SRV728 SRV724 SRV742 SRV740 # Description of Part This page intentionally left blank Warranty for Heat & GLO Lifestyle Collection Fireplaces WarrantyDo not Discard this Manual